相关论文: Predictability of reset switching voltages in unip…
Unipolar switching phenomena have attracted a great deal of recent attention, but the wide distributions of switching voltages still pose major obstacles for scientific advancement and practical applications. Using NiO capacitors, we…
We report the detailed current-voltage (I-V) characteristics of resistance switching in NiO thin films. In unipolar resistance switching, it is commonly believed that conducting filaments will rupture when NiO changes from a low resistance…
We fabricated Pt/NiO/Pt capacitor structures with various bottom electrode thicknesses, $t_{BE}$, and investigated their resistance switching behaviors. The capacitors with $t_{BE} \geq 50$ nm exhibited typical unipolar resistance memory…
We show that Joule heating causes current-controlled negative differential resistance (CC-NDR) in TiO2 by constructing an analytical model of the voltage-current V(I) characteristic based on polaronic transport for Ohm's Law and Newton's…
We have measured the transition process from the high to low resistivity states, i.e., the reset process of resistive switching based memristors based on Ni/HfO2/Si-n+ structures, and have also developed an analytical model for their…
We observed two types of unipolar resistance switching (RS) in NiO film: memory RS at low temperature and threshold RS at high temperature. We explain these phenomena using a bond percolation model that describes the forming and rupturing…
We investigated the 1/f noise of Pt/NiO/Pt capacitors that show unipolar resistance switching. When they were switched from the low to high resistance states, the power spectral density of the voltage fluctuation was increased by…
BiFeO3 thin films are deposited on FTO coated glass substrates using a simple sol-gel deposition technique, limiting thickness about 70 nm and Ag/BiFeO3/FTO RRAM devices are prepared. The devices showed low-voltage bipolar switching with…
In this work, we investigate the behavior of Al2O3/TiO2-x cross-point memristors in cryogenic environment. We report successful resistive switching of memristor devices from 300 K down to 1.5 K. The I-V curves exhibit negative differential…
The high reset current, IR, in unipolar resistance switching is an important issue which should be resolved for practical applications in nonvolatile memories. We showed that,during the forming and set processes, the compliance current,…
The abrupt metal insulator transition in $VO_2$ is attracting considerable interest from both fundamental and applicative angles. We report on DC I-V characteristics measured on $VO_2$ single crystals in the two-probe configuration at…
Memory devices based on resistive switching (RS) have not been fully realised due to lack of understanding of the underlying switching mechanisms. Nature of ion transport responsible for switching and growth of conducting filament in…
Solid state ionic conductors are good candidates for the next generation of nonvolatile computer memory elements. Such devices have to show reproducible resistance switching at reasonable voltage and current values even if scaled down to…
In the present work, multi-level resistive switching (RS) in W/Co:TiO2/FTO structures induced by a multi-mixed mechanism was studied. It was found that the devices could be reproducibly programmed into three nonvolatile resistance states.…
We investigated third harmonic generation in NiO thin films, which exhibit unipolar resistance switching behavior. We found that the low resistance states of the films were strongly nonlinear, with variations in the resistance R as large as…
A prerequisite to using the net spin polarization generated by a source-drain bias in three-dimensional topological insulators for spintronic applications, is understanding how such a bias alters the transport properties of these materials.…
This study demonstrates multilevel switching at 1.5 K of Al2O3/TiO2-x resistive memory devices fabricated with CMOS-compatible processes and materials. The I-V characteristics exhibit a negative differential resistance (NDR) effect due to a…
Electrical characteristics of a Co/TiO_x/Co resistive memory device, fabricated by two different methods are reported. In addition to crystalline TiO_2 layers fabricated via conventional atomic layer deposition (ALD), an alternative method…
The intrinsically rectifying-resistive switching (IR-RS) has been regarded as an effective way to address the crosstalk issue, due to the Schottky diodes formed at the metal/oxide interfaces in the ON states to suppress the sneak current at…
The layered compound BaCo1-xNixS2-y (0.05<x<0.2 and 0.05<y<0.2) exhibits an unusual first-order structural and electronic phase transition from a low-T monoclinic paramagnetic metal to a high-T tetragonal antiferromagnetic insulator around…