相关论文: Low-temperature formation of platinum silicides on…
We propose a way of formation of thin bilayer Pt$_3$Si/Pt$_2$Si films at room temperature on poly-Si substrates by Pt magnetron sputtering and wet etching, obtain such film, investigate its structure and phase composition and estimate the…
We report the synthesis of polycrystalline (poly)-SiGe alloy thin films through solid state reaction of Si/Ge multilayer thin films on Si and glass substrates at low temperature of 500 {\deg}C. The pristine thin film was deposited using…
Thin films of superconducting V$_3$Si were prepared by means of RF sputtering from a compound V$_3$Si target at room temperature onto sapphire and oxide-coated silicon wafers, followed by rapid thermal processing under secondary vacuum. The…
V$_3$Si thin films are known to be superconducting with transition temperatures up to 15 K, depending on the annealing temperature and the properties of the substrate underneath. Here we investigate the film structural properties with the…
We demonstrate electron cooling in silicon using platinum silicide as a superconductor contact to selectively remove the highest energy electrons. The superconducting critical temperature of bulk PtSi is reduced from around 1 K to 0.79 K…
Vanadium silicide (V$_3$Si) is a promising superconductor for integration with silicon-based electronics, however the interfacial growth kinetics have a strong influence on the resulting superconducting properties and are not yet fully…
Layered two-dimensional (2D) materials display great potential for a range of applications, particularly in electronics. We report the large-scale synthesis of thin films of platinum diselenide (PtSe2), a thus far scarcely investigated…
During the growth of metal thin films on dielectric substrates at a given deposition temperature T, the film's morphology is conditioned by the magnitude and asymmetry of up- and downhill diffusion. Any severe change of this mechanism leads…
Lead based relaxor ferroelectric thin films have been of technological importance due to excellent properties for several commercial applications. However subtleness and high cost of fabrication have plagued of these materials. In this work…
Platinum silicide Schottky diodes formed on films of polycrystalline Si doped by phosphorus are demonstrated to be efficient and manufacturable CMOS-compatible temperature sensors for microbolometer detectors of radiation. Thin-film…
The formation of Ni(Pt)silicides on a Si(001) surface is investigated using an ab initio approach. After deposition of a Ni overlayer alloyed with Pt, the calculations reveal fast diffusion of Ni atoms into the Si lattice, which leads…
Raman studies of nanocomposite SiCN thin film by sputtering showed that with an increase of substrate temperature from room temperature to 500oC, a transition from mostly sp2 graphitic phase to sp3 carbon took place which was observed from…
The preparation in thin film form of the known icosahedral phase in Ti-Ni-Zr bulk alloys has been investigated as a function of substrate temperature. Films were deposited by Pulsed Laser Deposition on sapphire substrates at temperatures…
We report optical characterization of PtSi films for thermoelectric device applications by nondestructive spectroscopic ellipsometry (SE). Pt monolayer and Pt-Si multilayer which consists of 3 pairs of Pt and Si layers were deposited on…
The synthesis of transition metal dichalcogenides (TMDs) has been a primary focus for 2D nanomaterial research over the last 10 years, however, only a small fraction of this research has been concentrated on transition metal ditellurides.…
Highly porous Pt/Al thin film electrodes on yttria stabilized zirconia electrolytes were prepared by dealloying of co-sputtered Pt/Al films. The oxygen reduction capability of the resulting electrodes was analyzed in a solid oxide fuel cell…
The effect of platinum (Pt) bottom electrode texture on the tetragonality, dielectric, ferroelectric, and polarization switching response of pulsed laser deposited Ba0.8Sr0.2TiO3 (BST) thin films has been studied. The x-ray diffraction and…
We studied the formation of the liquid-crystalline (LC) phase in a poly(di-n-hexylsilane)(PDHS) film at the heating above the thermochromic transition temperature and its evolution.
Diffusion mediated interaction in metal-substrate assembly during high temperature annealing leads to possible formation of new composite materials. Here, sputtered grown Ti films on Si3N4/Si substrate has been reported to produce titanium…
Pb(Zr0.52Ti0.48)O3 (PZT) thin films were in situ deposited by pulsed laser deposition (PLD) on Pt/Ti/SiO2/Si substrates using a template layer derived by sol-gel method. A 0.1-$\mu$m-thick PZT layer with (111) or (100)-preferred orientation…