相关论文: Growth mechanism of superconducting MgB2 films pre…
Growth of MgB2 thin films by pulsed laser deposition is examined under ex situ and in situ processing conditions. For the ex situ process, Boron films grown by PLD were annealed at 900 C with excess Mg. For the in situ process, different…
Thin superconducting films of magnesium diboride (MgB2) with Tc \approx 24K were prepared on various oxide substrates by pulsed laser deposition (PLD) followed by an in-situ anneal. A systematic study of the influence of various in-situ…
Superconducting MgB(2) films with Tc = 38.6 K were prepared using a precursor-deposition, ex-situ post-processing approach. Precursor films of boron, ~0.5 micrometer thick, were deposited onto Al(2)O(3) (102) substrates by e-beam…
Superconducting MgB2 thin films were prepared on Al2O3(0001) and MgO(100) substrates. Boron thin films were deposited by the electron-beam evaporation followed by post-annealing process with magnesium. Proper post annealing conditions were…
In this paper we report a new sol-gel method for the fabrication of MgB2 films. Polycrystalline MgB2 films were prepared by spin-coating a precursor solution of Mg(BH_4)_2 diethyl ether on (001)Al2O3 substrates followed with annealing in Mg…
We introduce a simple method of an MgB2 film preparation using sequential electron-beam evaporation of B-Mg two-layer (followed by in-situ annealing) on the NbN buffered Si(100) substrate. The Transmission Electron Microscopy analyses…
The electronic anisotropy in MgB2, is still a not completely clear topic; high quality c-oriented films are suitable systems to investigate this property. In this work we present our results on MgB2 superconducting thin films grown on MgO…
We have investigated the thermodynamic and kinetic barriers involved in the synthesis of MgB2 films. This work refines our initial conjectures predicting optimal MgB2 thin film growth conditions as a consequence of the unusually large…
We report the growth and properties of epitaxial MgB2 thin films on (0001) Al2O3 substrates. The MgB2 thin films were prepared by depositing boron films via RF magnetron sputtering, followed by a post-deposition anneal at 850C in magnesium…
As-grown superconducting MgB_2 thin films have been grown on SrTiO_3(001), MgO(001), and Al_2O_3(0001) substrates by a molecular beam epitaxy (MBE) method with novel co-evaporation conditions of low deposition rate in ultra-high vacuum. The…
We present a study on the power dependence of the microwave surface impedance in thin films of the novel superconductor MgB2. 500 nm thick samples exhibiting critical temperatures ranging between 26 and 38 K are synthesized by an ex-situ…
High quality MgB2 thin films have been obtained by pulsed laser deposition both on MgO and on Al2O3 substrates using different methods. In the standard two-step procedure, an amorphous precursor layer is deposited at room temperature…
Superconducting MgB2 thin films were prepared on 50-micrometer-thick, flexible polyamide Kapton-E foils by vacuum co-deposition of Mg and B precursors with nominal thickness of about 100 nm and a special ex-situ rapid annealing process in…
We have grown MgB2 films in a postannealing process. Precursors were prepared on Al2O3(0001) substrates by codeposition of Mg and MgB2 using pulsed laser deposition technique. Superconducting MgB2 thin films were obtained via an ex situ…
The in-situ growth of superconducting MgB2 thin films was examined from various perspectives. The paper discusses (1) growth temperature, (2) the effect of excess Mg, (3) the effect of residual gas during growth, (4) the effect of in-situ…
Superconducting magnesium diboride films with Tc0 ~ 24 K and sharp transition \~ 1 K were successfully prepared on silicon substrates by pulsed laser deposition from a stoichiometric MgB2 target. Contrary to previous reports, anneals at 630…
As-grown superconducting thin films of MgB2 were prepared by molecular beam epitaxy (MBE), and studied by X-ray and ultraviolet photoelectron spectroscopy (XPS and UPS). Only films prepared at temperatures between 150 and 320 deg. showed…
Superconducting thin films of MgB2 were deposited by Pulsed Laser Deposition on magnesium oxide and sapphire substrates. Samples grown at 450C in an argon buffer pressure of about 10-2 mbar by using a magnesium enriched target resulted to…
The electronic anisotropy in MgB2, which arises from its layered crystal structure is not completely clear until now. High quality c-oriented films offer the opportunity of studying such property. MgB2 thin films were deposited by using two…
The effects of Mg deficiency in MgB2 films grown by using hybrid physical-chemical vapor deposition were investigated after vacuum annealing at various temperatures. High-quality MgB2 films grown on c-cut Al2O3 substrates with different…