相关论文: Mechanism for Embedded In-plane Self Assembled Nan…
Starting from essentially flat nanometer-thick Fe films, epitaxially grown at room temperature on W(110) surfaces, we used carefully tuned annealing schedules to produce periodic arrays of nanoscale ferromagnetic wires. The structural…
We investigate the full and half-shells of Pb(1-x)Sn(x)Te topological crystalline insulator deposited by molecular beam epitaxy on the sidewalls of wurtzite GaAs nanowires (NWs). Due to the distinct orientation of the IV-VI shell with…
Non-Abelian anyons such as Majorana zero modes (MZMs) have the potential to enable fault-tolerant quantum computing through topological protection. Experimentally reported InSb topological superconductor nanowires (TSNW) are investigated…
The dynamics of magnetic flux quanta (Abrikosov vortices) determine the resistive response of superconductors. In pinning-free planar thin films, the penetration and motion of vortices are controlled by edge defects, leading to such…
It is shown that nanotubes with thicker walls can be grown from strongly bonded multi-layered structures only in accord with some basic crystallographic principles. Either the diameters of such tubes remain large in comparison with the…
Hybrid semiconductor-superconductor InAs-Al nanowires with uniform and defect-free crystal interfaces are one of the most promising candidates used in the quest for Majorana zero modes (MZMs). However, InAs nanowires often exhibit a high…
This work proposes new chemical and mechanical materials and techniques for III-V semiconductor NW/silicone membrane formation and optoelectronic device fabrication. Molecular beam epitaxy (MBE)-synthesized n-, p- and i-GaP NWs were…
High precision placement and integration of color centers in a silicon-based nanosystem, such as a nanowire (NW) array, exhibiting high integration functionality and high photoluminescence (PL) yield can serve as a critical building block…
With ZnTe as an example, we use two different methods to unravel the characteristics of the growth of nanowires by gold-catalyzed molecular beam epitaxy at low temperature. In the first approach, CdTe insertions have been used as markers,…
Ordered volume submicron surface structures "nanoflowers" - are obtained while growing metal nanowires in porous membranes by means of pulsed current electroplating. These structures occur if the electroplating is continued after the…
Directed atomic fabrication using an aberration-corrected scanning transmission electron microscope (STEM) opens new pathways for atomic engineering of functional materials. In this approach, the electron beam is used to actively alter the…
Macroscopic-scale nanostructures, situated at the interface of nanostructures and bulk materials, hold significant promise in the realm of thermoelectric materials. Nanostructuring presents a compelling avenue for enhancing material…
Two-dimensional materials with layered structures, appropriate bandgap, and high carrier mobilities have gathered tremendous interests due to their potential applications in optoelectronic and photovoltaic devices. Here, we report the…
Ultrathin InAs nanowires (NW) with one-dimensional (1D) sub-band structure are promising materials for advanced quantum-electronic devices, where dimensions in the sub-30 nm diameter limit together with post-CMOS integration scenarios on Si…
In a combined experimental and theoretical study, we investigate the influence of the material source arrangement in a molecular beam epitaxy (MBE) system on the growth of nanowire (NW) core-shell structures. In particular, we study the…
A procedure to achieve the density-controlled growth of gold-catalyzed InP nanowires (NWs) on (111) silicon substrates using the vapor-liquid-solid method by molecular beam epitaxy is reported. We develop an effective and mask-free method…
One-dimensional (1D) nanostructures - nanowires (NWs) - exhibit promising properties for integration in different types of functional devices. Their properties can be enhanced even further or tuned for a specific application by combining…
Imposing additional confinement in two-dimensional (2D) materials can yield further control over the associated electronic, optical, and topological properties. However, synthesis of ultra-narrow nanoribbons (NRs) remains a challenge,…
In this study, InSb nanowires have been formed by electrodeposition and integrated into NW-FETs. NWs were formed in porous anodic alumina (PAA) templates, with the PAA pore diameter of approximately 100 nm defining the NW diameter.…
The hollow inside of single-wall carbon nanotubes (SWCNT) provides a unique degree of freedom to investigate chemical reactions inside this confined environment and to study the tube properties. It is reviewed herein, how encapsulating…