相关论文: Effects of Substrate Temperature on Indium Gallium…
Nanocrystals of indium oxide (In$_2$O$_3$) with sizes below 10 nm were prepared in alumina matrixes by using a co-pulverization method. The used substrates such as borosilicate glasses or (100) silicon as well as the substrate temperatures…
Pulsed laser deposition from a Nd:YAG laser was employed in production of hundreds of nanometer thick quasicrystalline Ti-Zr-Ni films on glass substrate. The influence of deposition temperature Ts on the structure, morphology and…
We report the low temperature growth of vertically aligned ZnO nanocolumns on Si substrates by using reactive radio frequency magnetron sputtering.High sputtering pressure combined with low substrate temperatures induce a pronounced self…
In order to get homogeneous nanostructured Aluminum Nitride deposits, thin films were grown at room temperature on [001] Si substrates by radio frequency magnetron reactive sputtering. The deposits were analysed by Transmission Electron…
Structural and superconducting properties of high quality Niobium nanofilms with different thicknesses are investigated on silicon oxide and sapphire substrates. The role played by the different substrates and the superconducting properties…
We report on an XPS study of AlN thin films grown on Si(100) substrates by ion beam sputter deposition (IBSD) in reactive assistance of N+/N2+ ions to unravel the compositional variation of their surface when deposited at different…
Al2O3 thin films have been deposited at substrate temperatures between 500{\deg}C to 600{\deg}C by reactive magnetron sputtering using an additional arbitrary substrate bias to tailor the energy distribution of the incident ions. The films…
We report on the structural and magnetic properties of thin Ge(1-x)Mn(x)films grown by molecular beam epitaxy (MBE) on Ge(001) substrates at temperatures (Tg) ranging from 80deg C to 200deg C, with average Mn contents between 1 % and 11 %.…
Varying the substrate temperature changes structural and magnetic properties of spinel ferrite NZFO thin films. XRD of films grown at different temperature display only 004 reflections, without any secondary peaks, showing growth…
Al-doped ZnO thin films were deposited using reactive high power impulse magnetron sputtering at substrate temperatures between room temperature and 600 $\bullet$ C. Two sample series with different oxygen partial pressures were studied.…
Selective area growth of InN nanorods by plasma assisted molecular beam epitaxy is demonstrated. Molybdenum is found to be a suitable mask material at the low substrate temperature of 475 C needed for the growth of InN nanocolumns. The…
The authors have shown that nanogranular indium tin oxide (ITO) films, deposited by spray pyrolysis on silicon substrate, demonstrate ultralow thermal conductivity ~ 0.84 +/-0.12 Wm-1K-1 at room temperature. This value is approximately by…
The structure, composition and electrophysical characteristics of low-temperature silicon dioxide films under influence of various technology factors, such as ion implantation, laser irradiation, thermal and photonic annealing, have been…
Tantalum nitride thin films have been grown by in situ nitrogen implantation of metallic tantalum at room temperature over the energy range of 0.5-5keV. X-ray photoelectron spectroscopy (XPS) and Factor Analysis (FA) have been used to…
The performance of superconducting microwave circuits is strongly influenced by the material properties of the superconducting film and substrate. While progress has been made in understanding the importance of surface preparation and the…
Gallium nanoparticles (Ga-NPs) exhibit promising plasmonic properties spanning ultraviolet to infrared spectral regions, making them suitable for diverse nanophotonic applications. However, the synthesis of uniform and ordered Ga-NP arrays…
The use of highly efficient and solarblind GaN photocathodes as part of multichannel plate UV detectors for applications in astronomy would strongly benefit from the direct growth of GaN on typical window materials with high transmission…
The pattern and profile of a dried colloidal deposit formed after evaporation of a sessile water droplet containing polystyrene particles on a non-uniformly heated glass are investigated experimentally. In particular, the effects of…
Raman studies of nanocomposite SiCN thin film by sputtering showed that with an increase of substrate temperature from room temperature to 500oC, a transition from mostly sp2 graphitic phase to sp3 carbon took place which was observed from…
AlN thin films have been grown on Si (100) substrates by reactive ion beam sputter deposition (IBSD) at different substrate temperatures varying from room temperature (RT) to 500oC. Substrate temperature induced microstructural transition…