相关论文: Fabrication, optical characterization and modeling…
Al(0.37)Ga(0.63)As nanowires (NWs) were grown in a molecular beam epitaxy system on GaAs(111)B substrates. Micro-photoluminescence measurements and energy dispersive X-ray spectroscopy indicated a core-shell structure and Al composition…
InAs nanowires were grown on GaAs substrates by the Au-assisted vapour-liquid-solid (VLS) method in a gas source molecular beam epitaxy (GS-MBE) system. Passivation of the InAs nanowires using InP shells proved difficult due to the tendency…
We employ three dimensional x-ray coherent diffraction imaging to map the lattice strain distribution, and to probe the elastic properties of a single crystalline Ni (001) nanowire grown vertically on an amorphous Si02 || Si substrate. The…
We report a combined electron transmission and Raman spectroscopy study of InAs nanowires. We demonstrate that the temperature dependent behavior of optical phonon energies can be used to determine the relative wurtzite fraction in the InAs…
GaAs/Fe$_{3}$Si core/shell nanowire structures were fabricated by molecular-beam epitaxy on oxidized Si(111) substrates and investigated by synchrotron x-ray diffraction. The surfaces of the Fe$_3$Si shells exhibit nanofacets. These facets…
We predict that conduction electrons in a semiconductor film containing a centered square array of metal nanowires normal to its plane are bound in quantum states around the central wires, if a positive bias voltage is applied between the…
Evidence is given for the effectiveness of InAs surface passivation by the growth of an epitaxial InAlAs shell. The electron mobility is measured as a function of temperature for both core-shell and unpassivated nanowires, with the…
The thermal gradient along indium-arsenide nanowires was engineered by a combination of fabricated micro- trenches in the supporting substrate and focused laser irradiation. This allowed local control of thermally activated oxidation…
Here we report on non-uniform shell growth of In(x)Ga(1-x)As onto GaAs nanowire (NW) core by molecular beam epitaxy (MBE). The growth was realized on pre-patterned silicon substrates with pitch size (p) ranging from 0.1 um to 10 um.…
We consider electrons in tubular nanowires with prismatic geometry and infinite length. Such a model corresponds to a core-shell nanowire with an insulating core and a conductive shell. In a prismatic shell the lowest energy states are…
Electrical conductance through InAs nanowires is relevant for electronic applications as well as for fundamental quantum experiments. Here we employ nominally undoped, slightly tapered InAs nanowires to study the diameter dependence of…
Magneto-photoluminescence measurements of individual zinc-blende GaAs/AlAs core/shell nanowires are reported. At low temperature a strong emission line at 1.507 eV is observed under low power (nW) excitation. Measurements performed in high…
InN nanowires were grown on Si<111> and Si<100> substrates by plasma-assisted molecular beam epitaxy using a thin AlN buffer layer at temperatures compatible with the thermal budget limitation imposed by Back-End-Of-Line processing.…
The exciton states of strained CdTe/CdS core-shell tetrapod-shaped nanocrystals were theoretically investigated by the numerical diagonalization of a configuration interaction Hamiltonian based on the single-band effective mass…
Hybrid semiconductor-superconductor InAs-Al nanowires with uniform and defect-free crystal interfaces are one of the most promising candidates used in the quest for Majorana zero modes (MZMs). However, InAs nanowires often exhibit a high…
We have carried out first principles electronic structure and total energy calculations for a series of ultrathin aluminum nanowires, based on structures obtained by relaxing the model wires of Gulseren et al. The number of conducting…
Amorphous Co-rich microwires with excellent soft magnetic and mechanical properties produced by melt-extraction technique are emerging as a multifunctional material for a variety of applications ranging from ultrasensitive magnetic field…
Samples suitable for electron diffraction studies must satisfy certain characteristics such as having a thickness in the range of 10 - 100 nm. We report, to our knowledge, the first successful synthesis technique of nanometer-thin sheets of…
We report on the fabrication and electrical characterization of field-effect devices based on wire-shaped InP crystals grown from Au catalyst particles by a vapor-liquid-solid process. Our InP wires are n-type doped with diameters in the…
This study presents a numerical investigation of solid-core photonic crystal fibers with circular and hexagonal cladding geometries. The goal is to optimize optical parameters for nonlinear photonics and environmental sensing.…