相关论文: High quality c-axis oriented ZnO thin-film obtaine…
Zinc oxide is a wide-bandgap semiconductor which is considered a potential candidate for fabricating next-generation transparent spintronic devices. However, before this can be practically achieved, a thorough, scientific understanding of…
RF sputtered ZnO and Al:ZnO films are attractive transparent conductive oxides for fabrication of opto-electronic devices. In this paper we present efforts to control carrier concentration and mobility of ZnO/Al:ZnO thin films by…
This investigation deals with the effect of annealing temperature on the structural, topographical and optical properties of Zinc Oxide thin films prepared by sol gel method. The structural properties were studied using X-ray diffraction…
Surface-patterned ZnO thin films were fabricated by direct imprinting on ZnO sol and subsequent annealing process. The polymer-based ZnO sols were deposited on various substrates for the nanoimprint lithography and converted to…
A novel sol-gel route to c-axis orientated undoped and Co, Fe, Mn and V doped ZnO films is reported. Sols were prepared from a hydrated zinc acetate precursor and dimethyl formamide (DMF) solvent. Films were spin-coated on to hydrophilic…
Sol-gel spin coating technique was employed to synthesize CuO thin films at 1500 rpm, 2200 rpm and 2400 rpm for 30 seconds, and subsequently annealed at 150-550{\deg}C for 1 hour. Multi-layered CuO thin films with 3 and 5 layers were…
Ca- and Zn-subsituted Y1-xCaxBa2(Cu1-yZny)O7-delta (x = 0, 0.05 and y = 0, 0.02, 0.04, 0.05) thin films were grown on SrTiO3 (100) substrates using the pulsed laser deposition (PLD) technique. Effects of various growth parameters on the…
High quality ZnO thin films were gown using the pulsed laser deposition technique on (0001) Al$_2$O$_3$ substrates in an oxidizing atmosphere, using a Zn metallic target. We varied the growth conditions such as the deposition temperature…
The magnetic easy axis orientation was studied by the third order perturbed Heisenberg Hamiltonian. Ferromagnetic CoPt/AlN multilayer thin films with number of layers N=11, 16 and 21 synthesized on fused quartz substrates using dc magnetron…
The present study describes a facile route of zinc oxide (ZnO) grows using the solution-dependent electrostatic spray deposition (ESD) method at temperatures ranging from 300 {\deg}C - 500 {\deg}C. In this work, zinc chloride (ZnCl2) was…
In the present work, ultrathin films of Zinc oxide (ZnO) and Aluminum doped zinc oxide (AZO) with 20 nm thick were fabricated at 300 K on glass and Polyethylene terephthalate (PET) substrates by means of directcurrent sputtering method. The…
A comparative study of the physical properties of undoped Zinc Oxide (ZnO) and Al doped Zinc Oxide (AZO) thin films were performed as a function of annealing temperature. The structural properties were analyzed using X-ray diffraction and…
In the present study we report on properties of ZnCoO films grown at relatively low temperature by the Atomic Layer Deposition, using two reactive organic zinc precursors (dimethylzinc and diethylzinc). The use of these precursors allowed…
Thin films of magnesium doped zinc oxide (MZO) were synthesized using the sol gel method and annealed at different temperatures under ambient condition. The morphological properties of the post annealed MZO films were investigated using X…
Pb(Zr0.52Ti0.48)O3 (PZT) thin films were in situ deposited by pulsed laser deposition (PLD) on Pt/Ti/SiO2/Si substrates using a template layer derived by sol-gel method. A 0.1-$\mu$m-thick PZT layer with (111) or (100)-preferred orientation…
The magneto-transport properties of nanocomposite C:Co (15 and 40 at.% Co) thin films are investigated. The films were grown by ion beam co-sputtering on thermally oxidized silicon substrates in the temperature range from 200 to 500 degC.…
The chemical deposition of high-performance Zinc Oxide (ZnO) thin films is challenging, thus significant efforts have been devoted during the past decades to develop cost-effective, scalable fabrication methods in gas phase. This work…
Spin coating technique was used to synthesize pure ZnO and Cu doped ZnO films on amorphous and conducting glass substrates. The doped amount of Cu in ZnO was varied up to 5% in atomic percentage. Speed of spin coating system, coating time,…
The transverse magnetoresistance of thin films of the Diluted Magnetic Semiconductor Zn$_{1-x}$Co$_{x}$O:Al on glass was studied for temperatures in the range of 5 to 100 K. Measurements were made on thin films grown by rf magnetron…
In this Chapter we review our latest results on magnetic (AC susceptibility) and transport (resistivity) properties of Pr1.85Ce0.15CuO4 (PCCO) and Sm1.85Ce0.15CuO4 (SCCO) thin films grown by pulsed laser deposition technique. Three main…