相关论文: Thinned GaInP/GaInAs/Ge solar cells grown with red…

Virtual substrates based on thin Ge layers on Si by direct deposition have achieved high quality recently. Their application to high efficiency III-V solar cells is analyzed in this work. Replacing traditional Ge substrates with Ge/Si…

Solar cells manufactured on top of Ge substrates suffer from inherent drawbacks that hinder or limit their potential. The most deleterious ones are heavy weight, high bulk recombination, lack of photon confinement and an increase of the…

Multijunction solar cells are usually grown on Ge substrates. This implies several disadvantages that hinder the performance of the whole multijunction and limit their possible applications. The drawbacks caused by the substrate are:…

The growth of heavily doped tunnel junctions in inverted metamorphic multijunction solar cells induces a strong diffusion of Zn via a point-defects-assisted mechanism. The redistribution of Zn can compensate the n-type doping in the emitter…

Multijunction solar cell design is guided by both the theoretical optimal bandgap combination as well as the realistic limitations to materials with these bandgaps. For instance, triple-junction III-V multijunction solar cells commonly use…

A tandem GaAsP/SiGe solar cell has been developed employing group-IV reverse buffer layers grown on silicon substrates with a subsurface porous layer. Reverse buffer layers facilitate a reduction in the threading dislocation density with…

This paper proposes an efficient three-layered p-GaAs/p-CIGS/n-CdS (PPN), a unique solar cell architecture. Copper indium gallium selenide (CIGS)-based solar cells exhibit substantial performance than the ones utilizing cadmium sulfide…

To date, high efficiency multijunction solar cells have been developed on Ge or GaAs substrates for space applications, and terrestrial applications are hampered by high fabrication costs. In order to reduce this cost, we propose a…

Here we present the experimental results of an inverted three-terminal heterojunction bipolar transistor solar cell (HBTSC) made of GaInP/GaAs. The inverted growth and processing enable contacting the intermediate layer (base) from the…

Reverse biasing triple-junction GaInP/Ga(In)As/Ge solar cells may affect their performance by the formation of permanent shunts even if the reverse breakdown voltage is not reached. In previous works, it was observed that, amid the three…

The efficiency of GaAs nanowire solar cells can be significantly improved without any new processing steps or material requirements. We report coupled optoelectronic simulations of a GaAs nanowire (NW) solar cell with vertical p-i-n…

We report a novel graded refractive index antireflection coating for III/V quadruple solar cells based on bottom-up grown tapered GaP nanowires. We have calculated the photocurrent density of an InGaP-GaAs-InGaAsP-InGaAs solar cell with a…

This study investigates a four-terminal mechanically stacked double junction photovoltaic device based on GaAs as a top subcell and Si as a bottom subcell. Unlike two terminal monolithically series connected double junction photovoltaics,…

The InAs/InGaAs DWELL solar cell grown by MBE is a standard pin diode structure with six layers of InAs QDs embedded in InGaAs quantum wells placed within a 200-nm intrinsic GaAs region. The GaAs control wafer consists of the same pin…

In this study, we designed and optimized the performance of pin junction GaAs/AlGaAs heterojunction nanowire solar cell arrays. It is done by performing coupled optoelectronic simulations to find the optimal doping for the GaAs core and…

In this paper, we have designed and investigated the performance of radial GaAs/AlGaAs pin junction nanocone array solar cells by performing coupled optoelectronic simulations to obtain the most optimal design configuration based on its…

This paper addresses the influence of III-V nucleation routines on Ge substrates for the growth of high efficiency multijunction solar cells. Three exemplary nucleation routines with differences in thickness and temperature were evaluated.…

We present inverted metamorphic Ga0.3In0.7As photovoltaic converters with sub-0.60 eV bandgaps grown on InP and GaAs substrates. The compositionally graded buffers in these devices have threading dislocation densities of 1.3x10^6 cm^-2 and…

Following letter introduces a theoretical approach to investigate the effect of two-step GaN barrier layer growth methodology on the performance of InGaN/GaN MQW solar cell, in which a lower temperature GaN cap layer was grown on top of…

In this paper we carried out theoretical study of the general issues related to the efficiency of SiC:H/a-Si:H single- and multi-junction tandem solar cells. Implementation of numerical simulations by the use of AMPS-1D program of…