相关论文: Characterization of solution processed TiOx buffer…

Nanostructured TiO2 thin films were prepared by pulsed laser deposition (PLD) on indium doped tin oxide (ITO) substrates. Results from X-ray photoelectron spectroscopy (XPS) show that Ti 2p core level peaks shift toward the lower binding…

Multiferroic bismuth ferrite (BiFeO3) thin films were prepared by pulsed laser deposition (PLD) technique. Electronic structures of the film have been studied by in situ photoemission spectroscopy (PES) and x-ray absorption spectroscopy…

Thin TiO2 films on quartz substrates were prepared by spin coating of undoped and metal-ion-doped Sol Gel precursors. These films were characterised by Scanning Electron Microscopy, Laser Raman Microspectroscopy, Xray Diffraction and UV Vis…

This work reports a pulsed laser-assisted synthesis, detailed structural characterization, and study of plasmonic properties of three sets of TiN/TiNO thin films with high electron density. The first two sets of TiN films were grown at 600C…

Submicron core/shell Ti/TiOx photocatalyst is successfully synthesized via single-mode magnetic microwave (SMMW) assisted direct oxidation of planetary ball-milled TiH2. The thickness of TiOx shell including highly concentrated defects such…

Room temperature ferromagnetism is observed in undoped TiO2 films deposited on Si substrates using pulsed laser deposition (PLD). The ferromagnetic properties of the samples depend on the oxygen partial pressure during the PLD synthesis.…

$\textit{Ab initio}$ calculations were employed to investigate the effect of oxygen concentration dependent Ti vacancies formation on the core electron binding energy shifts in cubic titanium oxynitride (Ti$_{1-\delta}$O$_x$N$_{1-x}$). It…

The over threshold carbon-loadings (~50 at.%) of initial TiO2-hosts and posterior Cu-sensitization (~7 at.%) was made using pulsed ion-implantation technique in sequential mode with 1 hour vacuum-idle cycle between sequential stages of…

Thin films of Co-TiO2 are deposited on silicon and quartz substrates using Pulse Laser Deposition (PLD) process at various oxygen partial pressures ranging from 6.6 x 10-3 Pascals (Pa) to 53 Pa. Crystal structure, transport and magnetic…

Thin films of pure and self-deficient calcium titanites i.e., CaTiO$_3$, Ca$_{1-\alpha}$TiO$_3$, CaTi$_{1-\beta}$O$_3$ and CaTiO$_{3-\gamma}$ have been deposited on ITO substrate using dip coating method. X-ray diffraction and Scanning…

The structural interface properties of layered Pt/Ti/SiO2/Si electrodes have been investigated using high-resolution specular and diffuse x-ray reflectivity under grazing angles. Currently this multilayer system represents a technological…

The atomic structure and composition of non-interfacial ITO and ITO-Si interfaces were studied with Transmission Electron Microscopy (TEM) and X-ray Photoelectron Spectroscopy (XPS). The films were deposited by DC magnetron sputtering on…

Systematic investigation of atomic structure of N-ion implanted TiO2 (thin films and bulk ceramics) was performed by XPS measurements (core levels and valence bands) and first-principles density functional theory (DFT) calculations. In bulk…

We propose a systematic approach to obtain various forms of insulating titanium oxynitrides Ti$_{n}$N$_{2}$O$_{2n-3}$ and we conduct a detailed study on its $n=2$ case, Ti$_{2}$N$_{2}$O. We study the energetics and the electronic structures…

The results of XPS measurements (core levels and valence bands) of P+, Ca+, P+Ca+ and Ca+P+ ion implanted (E=30 keV, D=1x1017 cm-2) commercially pure titanium (cp-Ti) and first-principles density functional theory (DFT) calculations…

The deposition of a thin oxide layer at metal/semiconductor interfaces has been previously reported as a means of reducing contact resistance in 2D electronics. Using X-ray photoelectron spectroscopy with in-situ Ti deposition, we fabricate…

Terbium doped silicon oxynitride host matrix is suitable for various applications such as light emitters compatible with CMOS technology or frequency converter systems for photovoltaic cells. In this study, amorphous Tb3+ ion doped…

Interfacial bond formation during sputter deposition of metal oxide thin films onto polycarbonate (PC) is investigated by ab initio molecular dynamics simulations and X-ray photoelectron spectroscopy (XPS) analysis of PC | X interfaces (X =…

This work reports the fabrication and characterization of high-quality tungsten-doped vanadium dioxide (WxV1-xO2, x = 0~3 at. %) by thermal oxidation of sputtered tungsten-vanadium alloyed thin films with different atomic percentages and…

Low temperature solution combustion synthesis emerges as a facile method for synthesis of functional metal oxides thin films for electronic applications. We study the solution combustion synthesis process of Cu:NiOx using different molar…