相关论文: Fault-Tolerant Control of a 2 DOF Helicopter (TRMS…

Stability and satisfactory performance are critical control requirements for Unmanned Aerial Vehicle (UAV) applications. While conventional control systems for UAVs aim to ensure flight stability and safe operation while accomplishing…

Dual-system UAVs with vertical take-off and landing capabilities have become increasingly popular in recent years. As a safety-critical system, it is important that a dual-system UAV can maintain safe flight after faults/failures occur.…

This paper addresses Fault Tolerant Control (FTC) of Large Power Systems (LPS) subject to sensor failure. Hiding the fault from the controller allows the nominal controller to remain in the loop. We assume specific faults that violate…

This work presents a novel fault-tolerant control scheme based on active inference. Specifically, a new formulation of active inference which, unlike previous solutions, provides unbiased state estimation and simplifies the definition of…

Fault tolerance is achieved through multiply redundant hardware systems in large civil aircraft. This means of achieving fault tolerance is infeasible for small compact unmanned aerial vehicles. In this paper we apply a fault tolerant…

This study proposes a uniform passive fault-tolerant control (FTC) method for a quadcopter that does not rely on fault information subject to one, two adjacent, two opposite, or three rotors failure. The uniform control implies that the…

This paper aims to develop a Fault Tolerant Control (FTC) architecture, for the case of a damaged actuator for a multirotor UAV that can be applied across multirotor platforms based on their Attainable Virtual Control Set (AVCS). The…

Robustness and reliability are two key requirements for developing practical quantum control systems. The purpose of this paper is to design a coherent feedback controller for a class of linear quantum systems suffering from Markovian…

Propeller failure is a major cause of multirotor Unmanned Aerial Vehicles (UAVs) crashes. While conventional multirotor systems struggle to address this issue due to underactuation, over-actuated platforms can continue flying with…

PUBLISHED ON IEEE/ASME TRANSACTIONS ON MECHATRONICS, DOI: 10.1109/TMECH.2021.3100150. Ideally, accurate sensor measurements are needed to achieve a good performance in the closed-loop control of mechatronic systems. As a consequence, sensor…

This paper proposes an intelligent fault-tolerant control (FTC) strategy to tackle the trajectory tracking problem of an underwater vehicle (UV) under thruster damage (power loss) cases and meanwhile resolve the actuator saturation brought…

This paper presents a novel auto-tuning subsystem-based fault-tolerant control (SBFC) system designed for robotic manipulator systems with n degrees of freedom (DoF). It initially proposes a novel model for joint torques, incorporating an…

A general controller scheme for stabilizing a non-linear system, which has its origin from the linear system theory, is proposed in this paper. The proposed controller can stabilize the non-linear system subjected to initial conditions. An…

Although model-based fault tolerant control (FTC) has become prevalent in various engineering fields, its application to air-conditioning systems is limited due to the lack of control-oriented models to characterize the phase change of…

The paper addresses the issue of reliability of complex embedded control systems in the safety-critical environment. In this paper, we propose a novel approach to design controller that (i) guarantees the safety of nonlinear physical…

This paper considers the controllability analysis and fault tolerant control problem for a class of hexacopters. It is shown that the considered hexacopter is uncontrollable when one rotor fails, even though the hexacopter is over-actuated…

Isoperimetric robotic trusses can adapt to different tasks and environments because they have a high strength-to-weight ratio, can change their own shape dramatically, and can be reconfigured into a variety of different shapes. However,…

We propose a novel adaptive reinforcement learning control approach for fault tolerant control of degrading systems that is not preceded by a fault detection and diagnosis step. Therefore, \textit{a priori} knowledge of faults that may…

This study presents a transformer-based approach for fault-tolerant control in fixed-wing Unmanned Aerial Vehicles (UAVs), designed to adapt in real time to dynamic changes caused by structural damage or actuator failures. Unlike…

This paper presents an adaptive fault-tolerant control (FTC) scheme for a class of nonlinear uncertain multi-agent systems. A local FTC scheme is designed for each agent using local measurements and suitable information exchanged between…