相关论文: Inductances and attenuation constant for a thin-fi…

Advancements in the fabrication of superconducting quantum devices have highlighted tantalum as a promising material, owing to its low surface oxidation microwave loss at low temperatures. However, tantalum films exhibit significantly…

We have studied superconducting coplanar-waveguide (CPW) resonators fabricated from disordered (granular) films of Aluminum. Very high kinetic inductance of these films, inherent to disordered materials, allows us to implement ultra-short…

We have studied Nb lambda/2 coplanar-waveguide (CPW) resonators whose resonant frequencies are 10-11 GHz. The resonators have different film thicknesses, t=0.05, 0.1, 0.2, and 0.3 um. We measured at low temperatures, T=0.02-5 K, one of the…

We designed and successfully fabricated an absorption-type of superconducting coplanar waveguide (CPW) resonators. The resonators are made from a Niobium film (about 160 nm thick) on a high-resistance Si substrate, and each resonator is…

Superconducting coplanar-waveguide (CPW) resonators are one of the key devices in circuit quantum electrodynamics (cQED). Their performance can be limited by dielectric losses in the substrate and in the material interfaces. Reliable…

We study the optical pulse response of a superconducting half-wavelength coplanar waveguide (CPW) resonator. We apply a short optical pulse to the center strip of the CPW resonator, where the current distribution shows antinodes or nodes…

In this paper, we report on the results of features in the discovered effect of a strong change in the microwave losses (quenching) in HTS-based coplanar waveguide (CPW) at certain values of the input power $P_{in}$ and direct current (DC)…

Superconducting coplanar waveguide (SCPW) resonators have a wide range of applications due to the combination of their planar geometry and high quality factors relative to normal metals. However, their performance is sensitive to both the…

Investigations into the propagation characteristics, specifically loss and wave velocity, of superconducting coplanar waveguides and microstrip lines were conducted at a 2 mm wavelength. This was achieved through the measurement of on-chip…

We present a novel lab-on-chip technique to measure the very low losses in superconducting transmission lines at (sub-) mm wavelengths. The chips consist of a 100 nm thick NbTiN Coplanar Waveguide (CPW) Fabry Perot (FP) resonator, coupled…

This work focuses on the development and demonstration of tunable superconducting on-chip resonator, leveraging the intrinsic current-dependent non-linear kinetic inductance of superconducting aluminium, and investigating the effect of…

As superconducting kinetic inductance detectors (KIDs) continue to grow in popularity for sensitive submillimeter detection and other applications, there is a drive to advance toward lower-loss devices. We present measurements of diagnostic…

Superconducting thin-films are central to the operation of many kinds of quantum sensors and quantum computing devices: Kinetic Inductance Detectors (KIDs), Travelling-Wave Parametric Amplifiers (TWPAs), Qubits, and Spin-based Quantum…

We investigate thin films of conducting aluminium-oxide, also known as granular aluminium, as a material for superconducting high quality, high kinetic inductance circuits. The films are deposited by an optimised reactive DC magnetron…

Dielectric losses are one of the key factors limiting the coherence of superconducting qubits. The impact of materials and fabrication steps on dielectric losses can be evaluated using coplanar waveguide (CPW) microwave resonators. Here, we…

Characterizing superconducting microwave resonators with highly dissipative elements is a technical challenge, but a requirement for implementing and understanding the operation of hybrid quantum devices involving dissipative elements, e.g.…

We present an experimental approach for cryogenic dielectric measurements on ultra-thin insulating films. Based on a coplanar microwave waveguide design we implement superconducting quarter-wave resonators with inductive coupling, which…

In this work, we implement a new London equation module for superconductivity in the GPU-enabled ARTEMIS framework, and couple it to a finite-difference time-domain solver for Maxwell's equations. We apply this two-fluid approach to model a…

The sensitivity of microwave kinetic inductance detectors (MKIDs) based on coplanar waveguides (CPWs) needs to be improved by at least an order of magnitude to satisfy the requirements for space-based terahertz astronomy. Our aim is to…

We have designed and fabricated superconducting coplanar waveguide resonators with fundamental frequencies from 2 to $9 \rm{GHz}$ and loaded quality factors ranging from a few hundreds to a several hundred thousands reached at temperatures…