相关论文: Linux-Based Toolkit in the VEPP-4 Control System

The ENUBET project is aimed at designing and experimentally demonstrating the concept of monitored neutrino beams. These novel beams are enhanced by an instrumented decay tunnel, whose detectors reconstruct large-angle charged leptons…

The new era of software signal processing has a large impact on radio astronomy instrumentation. Our design and implementation of a 32 antennae, 33 MHz, dual polarization, fully real-time software backend for the GMRT, using only…

The setups for precise measurements of the time structure of Nuclotron internal and slowly extracted beams are described in both hardware and software aspects. The CAMAC hardware is based on the use of the standard CAMAC modules developed…

Budker INP hosts two e+e- colliders, VEPP-4M operating in the beam energy range of 1-5.5 GeV and the low-energy machine VEPP-2000, collecting data at 160-1000 MeV per beam. The latter uses a novel concept of round colliding beams. The paper…

Geant4 is a tool kit developed by a collaboration of physicists and computer professionals in the High Energy Physics field for simulation of the passage of particles through matter. The motivation for the development of the Beam Tools is…

The SVOM Visible Telescope (VT) is critical for the rapid identification of gamma-ray burst (GRB) optical counterparts, particularly for high-redshift candidates that require immediate infrared spectroscopic follow-up. To address the…

In this paper, beam diagnostic and monitoring tools developed by the MAX IV Operations Group are discussed. In particular, new beam position monitoring and accelerator tunes visualization software tools, as well as tools that directly…

We present a fully modular and scalable software pipeline for processing electron microscope (EM) images of brain slices into 3D visualization of individual neurons and demonstrate an end-to-end segmentation of a large EM volume using a…

A pipeline CAMAC controller with PC/104-Plus single board computer has been developed. The architecture of the pipeline CAMAC controller is completely different from that of traditional CAMAC controller. The pipeline CAMAC controller…

Modern PC workstations often provide more CPU power than required for most control applications. On the other hand, the screen space is always in short supply. One possible solution is to use more PCs, but in fact we need only more screens,…

The Fermilab Accelerator Division, Instrumentation Department is adopting an open-source framework to replace our embedded VME-based data acquisition systems. Utilizing an iterative methodology, we first moved to embedded Linux, removing…

The Laser-wire will be an essential diagnostic tool at the International Linear Collider. It uses a finely focussed laser beam to measure the transverse profile of electron bunches by detecting the Compton-scattered photons (or degraded…

The growing research and industry interest in the Internet of Things and the edge computing paradigm has increased the need for cost-efficient virtual testbeds for large-scale distributed applications. Researchers, students, and…

A 70 GeV Proton Synchrotron Extracted Beam Lines Control System is described. About 130 Magnet Dipoles and Quadrupoles, 20 Correction Magnets, 50 Beam Collimators, BPM equipment spread over 1 Km have to be controlled. The old System was…

We present the hardware and software systems implementing autonomous operation, distributed real-time monitoring, and control for the EBEX instrument. EBEX is a NASA-funded balloon-borne microwave polarimeter designed for a 14 day Antarctic…

This paper presents a system consisting of the FPGA IP core, the simple network protocol and the Linux device driver, capable of efficient and reliable data transmission from a low resources FPGA chip to the Linux-based embedded computer…

A PC based high speed silicon microstrip beam telescope consisting of several independent modules is presented. Every module contains an AC-coupled double sided silicon microstrip sensor and a complete set of analog and digital signal…

This paper presents the development of a new software in order to manage objects, robots and mannequins in using the possibilities given by the haptic feedback of the Phantom desktop devices. The haptic device provides 6 positional degrees…

Modern precision experiments trapping low-energy particles require detailed simulations of particle trajectories and spin precession to determine systematic measurement limitations and apparatus deficiencies. We developed PENTrack, a tool…

The ENUBET ERC project (2016-2021) is studying a narrow band neutrino beam where lepton production can be monitored at single particle level in an instrumented decay tunnel. This would allow to measure $\nu_{\mu}$ and $\nu_{e}$ cross…