相关论文: A Proposal for Yield Improvement with Power Tradeo…

A Low-Power Variable Gain (VG) mm-Wave Low Noise Amplifier (LNA) is designed and simulated in a 28-nm CMOS process. The LNA utilizes a simple, yet novel, technique presented in this paper to vary the small-signal output resistance to…

This paper presents the analysis, design, fabrication, and measurement of an integrated low-noise amplifier (LNA) implemented using a 130 nm CMOS technology, operating in the 2.4 GHz band. The LNA is a crucial component in the performance…

A low-noise amplifier (LNA) amplifies a very low-power signal without significantly degrading its signal-to-noise ratio. This paper provides the design of a linear low noise amplifier with the transistor BFP 640 using bilateral approach…

As the Internet of Things (IOT) is growing rapidly, there is an emerging need to facilitate development of IOT devices in the design cycle while optimized performance is obtained in the field of operation. This paper develops…

This paper investigates the impact of technological constraints on passive elements in the design of inductively degenerated CMOS low-noise amplifiers (LNAs). A theoretical analysis is combined with circuit simulations in a 130-nm CMOS…

This paper demonstrates designing and developing of an Ultra-Low Noise Amplifier which should potentially increase the sensitivity of the existing Magnetic Resonance Imaging (MRI) systems. The Design of the LNA is fabricated and…

Noise level frequently set the basic limit on the smallest signal. New noise reduction technology and amplifiers voltage-noise density, yet still offer high speed, high accuracy, and low power solution. Low noise amplifiers always play a…

Implementation cost and power consumption are two important considerations in modern wireless communications, particularly in large-scale multi-antenna systems where the number of individual radio-frequency (RF) chains may be significantly…

This letter proposes a modified non-orthogonal multiple-access (NOMA) scheme for systems with a multi-antenna base station (BS) and two single-antenna users, where NOMA transmissions are conducted only when the absolute correlation…

With the extreme scaling, active devices in both CMOS and BiCMOS technologies have reached outstanding ft/fmax, enabling an ever-increasing number of existing and emerging applications in the microwave and millimeter wave (mm-wave)…

One of the major challenges in communication, radar, and electronic warfare receivers arises from nearby device interference. The paper presents a 2-6 GHz GaN LNA front-end with onboard sensing, processing, and feedback utilizing…

Next-generation (5G/6G) wireless systems demand low-power mm-wave phased-array ICs. Variable-gain LNAs (VGLNAs) are key building blocks enabling hardware complexity reduction, performance enhancement and functionality extension. This paper…

This paper presents a low-noise amplifier (LNA) that was developed for a new radio telescope comprised of 512 parabolic dish antennas. The LNA closely interfaces to a custom-made antenna feed with an impedance co-designed to provide noise…

Analog-to-digital converters (ADCs) are a major contributor to the power consumption of multiple-input multiple-output (MIMO) communication systems with large number of antennas. Use of low resolution ADCs has been proposed as a means to…

Next-generation cellular systems require low-power mm-wave phased-array ICs. Variable-gain LNAs (VG-LNAs) are key blocks enabling reduced hardware complexity, performance improvement and added functionalities. This paper reports a low-power…

To achieve the low noise and wide bandwidth required for millimeter wavelength astronomy applications, superconductor-insulator-superconductor (SIS) mixer based receiver systems have typically been used. This paper investigates the…

Traditionally, the output noise and power supply rejection of low-dropout regulators (LDOs) are optimized to minimize power supply fluctuations, reducing their impact on the low-frequency noise of target voltage-controlled oscillators…

A novel topology for a high gain two-stage amplifier is proposed. The proposed circuit is designed in a way that the non-dominant pole is at output of the first stage. A positive capacitive feedback (PCF) around the second stage introduces…

The progress of the Internet of Things(IoT) technologies and applications requires the efficient low power circuits and architectures to maintain and improve the performance of the increasingly growing data processing systems. Memristive…

A low power cascode SiGe BiCMOS low noise amplifier (LNA) with current reuse and zero-pole cancellation is presented for ultra-wideband (UWB) application. The LNA is composed of cascode input stage and common emitter (CE) output stage with…