相关论文: Characterization of a continuous muon source for t…

Muon-Induced X-ray Emission (MIXE) is a non-destructive analytical technique that leverages negative muons to probe elemental and isotopic compositions by detecting characteristic muonic X-rays emitted during atomic cascades and gamma rays…

The usage of muonic X-rays to study elemental properties like nuclear radii ranges back to the seventies. This triggered the pioneering work at the Paul Scherrer Institute (PSI), during the eighties, on the Muon Induced X-ray Emission…

Muon Induced X-ray Emission (MIXE) was discovered by Chinese physicist Zhang Wenyu as early as 1947, and it can conduct non-destructive elemental analysis inside samples. Research has shown that MIXE can retain the high efficiency of direct…

This paper presents the standardization of Proton Induced X-rays Emission (PIXE) technique for the trace element analysis of thick standard samples. Three standard reference materials (SRMs) viz-\`a-vis titanium, copper and iron base alloys…

A high-repetition-rate pulsed muon source operating at approximately 50\,kHz holds the potential to improve the sensitivity of various particle physics and material science experiments involving muons. In this article, we propose utilizing…

Proton Induced X-ray Emission (PIXE) using high energy protons is a non destructive multi elemental technique that can analyze medium and heavy trace elements on thick samples. A new experimental setup is being built at the ARRONAX facility…

A characteristic feature of the nuclear microprobe using a 3 MeV proton beam is the long range of particles (around 70 \mu m in light matrices). The PIXE method, with EDS analysis and using the multilayer approach for treating the X-ray…

Muons have established a unique and pivotal role in both fundamental physics and applied sciences. Given that a typical muon experiment spans roughly ten muon lifetimes, the optimal muon source should operate at around 50\,kHz in pulsed…

We present a comparative study of three Monte Carlo simulation frameworks -SRIM, GEANT4, and PHITS- for modeling the transport, stopping, and atomic cascade of negative muons in micrometer-scale, multilayer systems relevant to Muon-Induced…

The study of novel quantum materials relies on muon-spin rotation, relaxation, or resonance (\mSR) measurements. Yet, a fundamental limitation persists: many of these materials can only be synthesized in extremely small quantities, often at…

Gildings, patinas and alteration crusts are common features of many heritage artefacts, especially for metals. Their size depends on many factors, like the manufacturing method for gildings or the conservation state for alteration crusts:…

Muons have a similar latency/energy correlation from pion decay as do the neutrinos, and hence in each time-slice in a stroboscopic analysis measurements of their momentum spectra can reduce systematic uncertainties due to flux. There are,…

Muon beams of low emittance provide the basis for the intense, well-characterised neutrino beams of a neutrino factory and for multi-TeV lepton-antilepton collisions at a muon collider. The international Muon Ionization Cooling Experiment…

Muons are a fascinating probe to study nuclear properties. Muonic atoms can easily be formed by stopping negative muons inside a material. The muon is subsequently captured by the nucleus and, due to its much higher mass compared to the…

A CdTe double-sided strip detector (CdTe-DSD) is an ideal device for imaging and spectroscopic measure- ments in the hard X-ray range above 10 keV. Recent development enables us to realize an imager with a detection area of ~10 cm${^2}$. An…

A new experiment to quantitatively measure neutrons induced by cosmic-ray muons in selected high-Z materials is introduced. The design of the Muon-Induced Neutron Indirect Detection EXperiment, MINIDEX, and the results from its first data…

Muon tomography based on the measurement of multiple scattering of atmospheric cosmic ray muons is a promising technique for detecting and imaging heavily shielded high-Z nuclear materials such as enriched uranium. This technique could…

The civil engineering industry faces a critical need for innovative non-destructive evaluation methods, particularly for ageing critical infrastructure, such as bridges, where current techniques fall short. Muography, a non-invasive imaging…

Modulation of Intensity Emerging from Zero Effort (MIEZE) is a neutron resonant spin echo technique which allows one to measure time correlation scattering functions in materials by implementing radio-frequency (RF) intensity modulation at…

The Muon Scattering Experiment at the Paul Scherrer Institut uses a mixed beam of electrons, muons, and pions, necessitating precise timing to identify the beam particles and reactions they cause. We describe the design and performance of…