相关论文: Coherence and flow-maximization of a one-way valve

We consider an isothermal gas flowing through a straight pipe and study the effects of a two-way electronic valve on the flow. The valve is either open or closed according to the pressure gradient and is assumed to act without any time or…

The sliding mode approach is recognized as an efficient tool for treating the chattering behavior in hybrid systems. However, the amplitude of chattering, by its nature, is proportional to magnitude of discontinuous control. A possible…

Pressure-relief valves, often the critical last line of defence in process engineering, are known to be susceptible to valve chatter. Such behaviour has been shown to arise from a flutter instability, or Hopf bifurcation, associated with…

The present research is devoted to the problem of stability of the fluid flow moving in a channel with flexible walls and interacting with the walls, which are subject to traveling waves. Experimental data shows that the energy of the…

We are concerned with a one dimensional flow of a compressible fluid which may be seen as a simplification of the flow of fluid in a long thin pipe. We assume that the pipe is on one side ended by a spring. The other side of the pipe is let…

A detailed analysis is presented to demonstrate the capabilities of the lattice Boltzmann method. Thorough comparisons with other numerical solutions for the two-dimensional, driven cavity flow show that the lattice Boltzmann method gives…

The ensemble Kalman method is introduced for optimizing flow control strategies in order to mitigate the flow-induced vibration of structures. Different types of control strategies such as passive control, open-loop active control, and…

We suggest a simple model to describe polyamorphism in single-component fluids using a maximum-valence approach. The model contains three types of interactions: i) atoms attract each other by van der Waals forces that generate a liquid-gas…

We formulate a control system model for the distributed flow of mixtures of highly heterogeneous gases through large-scale pipeline networks with time-varying injections of constituents, withdrawals, and control actions of compressors. This…

Coherence between the velocity fluctuations measured at two points is investigated in a turbulent jet flow. Coherence is calculated in different regions of the flow by changing the separation between the points, the distance between the…

This paper is concerned with the transition of the laminar flow in a duct of square cross-section. Like in the similar case of the pipe flow, the motion is linearly stable for all Reynolds numbers, rendering this flow a suitable candidate…

We suggested a one-fluid model of a turbulent dilute suspension which accounts for the ``two-way'' fluid-particle interactions by $k$-dependent effective density of suspension and additional damping term in the Navier-Stokes equation. We…

We consider a control problem for longitudinal vibrations of a nonhomogeneous bar with clamped ends. The vibrations of the bar are controlled by an external force which is distributed along the bar. For the minimization problem of mean…

We formulate the optimal flow problem in a multi-area integrated electrical and gas system as a mixed-integer optimization problem by approximating the non-linear gas flows with piece-wise affine functions, thus resulting in a set of…

A fully conservative sharp-interface method is developed for multiphase flows with phase change. The coupling between two phases is implemented via introducing the interfacial fluxes, which are obtained by solving a general Riemann problem…

One-dimensional models are presented for transitional shear flows. The models have two variables corresponding to turbulence intensity and mean shear. These variables evolve according to simple equations based on known properties of…

The transition of the flow in a duct of square cross-section is studied. Like in the similar case of the pipe flow, the motion is linearly stable for all Reynolds numbers; this flow is thus a good candidate to investigate the 'bypass' path…

A proven methodology to solve multiphase flows is based on the one-fluid formulation of the governing equations, which treats the phase transition across the interface as a single fluid with varying properties and adds additional source…

This article presents the idea and realization for the unique Adaptive Inflow Control System being a part of well completion, able to adjust to the changing in time production conditions. This system allows to limit the flow rate from each…

The simulation of geometrically resolved rigid particles in a fluid relies on coupling algorithms to transfer momentum both ways between the particles and the fluid. In this article, the fluid flow is modeled with a parallel Lattice…