相关论文: Fault Tolerant Control of Automotive Air Condition…

In this paper, a novel partial form dynamic linearization (PFDL) data-driven model-free adaptive predictive control (MFAPC) method is proposed for a class of discrete-time single-input single-output nonlinear systems. The main contributions…

This paper develops a fault detection and identification (FDI) method for nonlinear control-affine systems under simultaneous actuator and sensor faults. We adopt a geometric approach to study the isolability of faults in the sense of the…

This paper considers the problem of fault detection and isolation (FDI) for switched affine models. We first study the model invalidation problem and its application to guaranteed fault detection. Novel and intuitive optimization-based…

Optimal control for safety-critical systems is often dependent on the conservativeness of constraints. Control Barrier Functions (CBFs) serve as a medium to represent such constraints, but constructing a minimally conservative CBF is a…

Since some years ago, use of Feedback Control Scheduling Algorithm (FCSA) in the control scheduling co-design of multiprocessor embedded system has increased. FCSA provides Quality of Service (QoS) in terms of overall system performance and…

We propose a novel adaptive reinforcement learning control approach for fault tolerant control of degrading systems that is not preceded by a fault detection and diagnosis step. Therefore, \textit{a priori} knowledge of faults that may…

Current model-free adaptive control (MFAC) can hardly deal with the time delay problem in multiple-input multiple-output (MIMO) systems. To solve this problem, a novel model-free adaptive predictive control (MFAPC) method is proposed.…

The advent of automated vehicles operating at SAE levels 4 and 5 poses high fault tolerance demands for all functions contributing to the driving task. At the actuator level, fault-tolerant vehicle motion control, which exploits functional…

Safety is one of the most important properties of control systems. Sensor faults and attacks and actuator failures may cause errors in the sensor measurements and system dynamics, which leads to erroneous control inputs and hence safety…

A novel active fault-tolerant control (AFTC) scheme for a dual-system vertical takeoff and landing (VTOL) unmanned aerial vehicle (UAV) during transition flight is proposed in this paper. The AFTC scheme is composed of a baseline control…

In this paper, a Fault-Tolerant control of 2 DOF Helicopter (TRMS System) Based on H-infinity is presented. In particular, the introductory part of the paper presents a Fault-Tolerant Control (FTC), the first part of this paper presents a…

This paper presents the results of a model predictive controller (MPC) development for diesel engine air-path regulation. The control objective is to track the intake manifold pressure and exhaust gas recirculation (EGR) rate targets by…

The extensive use of distributed vehicle platoon controllers has resulted in several benefits for transportation systems, such as increased traffic flow, fuel efficiency, and decreased pollution. The rising reliance on interconnected…

The aim of this paper is to propose an alternative method to solve a Fault Tolerant Control problem. The model is a linear system affected by a disturbance term: this represents a large class of technological faulty processes. The goal is…

Individual Pitch Control (IPC) is an effective and widely-used strategy to mitigate blade loads in wind turbines. However, conventional IPC fails to cope with blade and actuator faults, and this situation may lead to an emergency shutdown…

With increased developments and interest in cooperative driving and higher levels of automation (SAE level 3+), the need for safety systems that are capable to monitor system health and maintain safe operations in faulty scenarios is…

Positive-negative pressure regulation is critical to soft robotic actuators, enabling large motion ranges and versatile actuation modes. However, it remains challenging due to complex nonlinearities, oscillations, and direction-dependent,…

This article presents a novel perspective along with a scalable methodology to design a fault detection and isolation (FDI) filter for high dimensional nonlinear systems. Previous approaches on FDI problems are either confined to linear…

This study proposes a uniform passive fault-tolerant control (FTC) method for a quadcopter that does not rely on fault information subject to one, two adjacent, two opposite, or three rotors failure. The uniform control implies that the…

In this paper, a novel sensor fault detection, isolation and identification (FDII) strategy is proposed by using the multiple model (MM) approach. The scheme is based on multiple hybrid Kalman filters (HKF) which represents an integration…