相关论文: Development of high-performance iron-based superco…

Transport critical current (Ic) was measured for Fe-sheathed MgB2 round wires. A critical current density of 5.3 x 10^4 A/cm^2 was obtained at 32K. Strong magnetic shielding by the iron sheath was observed, resulting in a decrease in Ic by…

We have discovered that samples of a new material produced by special processing of crystals of Sr2RuO4 (which is known to be a triplet superconductor with Tc values ~1.0-1.5K) exhibit signatures of superconductivity (zero DC resistance and…

Magnesium diboride superconducting wires give the largest critical current density (Jc) when produced with iron sheath. Because iron is ferromagnetic, it is expected to improve the field dependence of Jc by shielding of the external field…

Scaling relations describing the electromagnetic behaviour of coated conductors (CCs) greatly simplify the design of REBCO-based devices. The performance of REBCO CCs is strongly influenced by fabrication route, conductor architecture and…

Superconductivity in iron pnictides is unconventional and pairing may be mediated by magnetic fluctuations in the Fe-sublattice. Pressure is a clean method to explore superconductivity in iron based superconductors by tuning the ground…

Understanding what makes Bi$_2$Sr$_2$Ca$_1$Cu$_2$O$_x$ (Bi-2212) the only high critical current density ($J_c$), high temperature superconductor (HTS) capable of being made as a round wire (RW) is important intellectually because high $J_c$…

We present electrical transport, magnetization, and specific heat measurements on bulk MgB2 samples (T_{c} = 38.5 K) synthesized under 200 MPa pressure using a process based on hot isostatic pressing with cooling under pressure. The samples…

Au and Ag are known to be metallic and none of them have shown independently superconductivity. Here we show superconductivity in Ag implanted Au thin films. Ag implanted Au films of different thicknesses have been studied using four probe…

The iron-based superconductor (IBS) single pancake coil (SPC) with 30 mm inner diameter was firstly fabricated and tested under 24 T background field. This SPC was successfully made using the 7-filamentary Ba1-xKxFe2As2 (Ba122) tape by…

It is generally argued that for high-temperature superconductors (HTS) to be cost-competitive in power applications, the wire will have to sell for about $10 per kiloampere meter ($10/kAm) for operation at 77 K (e.g., NbTi costs around…

The MgB2 superconductor has already demonstrated its applicative potential, in particular for DC applications such as MRI magnets, thanks to the low costs of the raw materials and to its simple production process. However further efforts…

Co-doped BaFe2As2 has been previously shown to have an unusually significant improvement of Tc (up to 2 K, or almost 10%) with annealing 1-2 weeks at 700 or 800 C, where such annealing conditions are insufficient to allow significant atomic…

In the last few years, a new type of Nb$_3$Sn superconducting composite, containing a high density of artificial pinning centers (APC) generated via an internal oxidation approach, has demonstrated a significantly superior performance…

Searching for superconducting materials with high transition temperature (TC) is one of the most exciting and challenging fields in physics and materials science. Although superconductivity has been discovered for more than 100 years, the…

REBCO coated conductor is a high temperature superconductor that has a wide range of applications, one of which is the current leads of magnet systems. In the design of current leads, it is crucial to minimize their thermal conduction while…

A new fabrication process for superconducting integrated digital circuits is reported. We have developed the "SIMIT Nb04" fabrication technique for superconducting integrated circuits with Nb-based Josephson junctions based on the validated…

Significant insights for critical current density (Jc) improvement in Bi-2212 super- conductor wires can be obtained by an accurate analysis of the structural and mi- crostructural properties evolving during the so-called partial-melt…

The critical current density Jc in high-Tc superconductors (HTS) often shows a maximum at field far above the self-field. We study this peak effect(PE) with the nonlinear I-V response of type-II superconductors and find analytical equation…

We demonstrate the fabrication of superconducting SmFeAsO1-xFx (Sm-1111) wires by using the ex-situ powder-in-tube technique. Sm-1111 powder and a binder composed of SmF3, samarium arsenide, and iron arsenide were used to synthesize the…

Thin films of the iron-based superconductor BaFe2(As1-xPx)2 (Ba122:P) were fabricated on polycrystalline metal-tape substrates with two kinds of in-plane grain boundary alignments (well aligned (4 deg.) and poorly aligned (8 deg.)) by…