相关论文: Development of high-performance iron-based superco…

In this work we investigate the effect of each different heat treatment stage in the fabrication of Bi2Sr2CaCu2O8+d superconducting wires on intra-grain and inter-grain superconducting properties. We measure magnetic critical temperature Tc…

Enhancements of superconducting properties were observed in FeSe wires using a quenching technique. Zero resistivity was achieved at about 10 K in quenched wires, which is about 2 K higher than that of polycrystalline FeSe bulk.…

Compounds of Sr1-xLaxFe2As2 were synthesized by solid state reaction at 1273 K, under pressures of 2 or 3 GPa. The Sr1-xLaxFe2As2 phase was dominant up to x = 0.5, and superconductivity was observed at $x \ge 0.2$. A maximum critical…

The powder-in-tube MgB2 wires were prepared by high energy milling of Mg and B powder. The powder was not mechanically alloyed for 2h short milling time. However, the MgB2 grains in wires are very small (20 100nm) and resembled to the…

High-quality FeSe tapes have been prepared by using a diffusion method. By adjusting the reaction temperature and the thickness systematically, a transport critical current density as high as 600 A/cm2 at 4.2 K under self field is achieved.…

We investigated the effect of nanoscale-C doping on the critical current density Jc and irreversibility field Birr of Fe-sheathed MgB2 tapes prepared by the in-situ powder-in-tube method. The tapes were heat treated at 600-950C for 1 h.…

High-performance solution-processed short-channel carbon nanotube (CNT) thin film transistors (TFTs) are fabricated using densely aligned arrays of metallic CNTs (m-CNTs) as source and drain electrodes, and aligned arrays of semiconducting…

Fe/MgB2 tapes have been prepared starting with pre-reacted binary MgB2 powders. As shown by resistive and inductive measurements, the reduction of particle size to a few microns by ball milling has little influence on Bc2, while the…

Superconducting Ag or Cu sheathed MgB2 wires have been fabricated by conventional powder-in-tube techniques. The in-situ reaction of Mg and B powders with atomic proportions of 1:2 and 1.33:2 inside Ag or Cu tubes at low temperatures have…

We report on significant flux pinning enhancement in MgB2/Fe tapes that has been easily obtained by a simple and cheap route using acetone as both an efficient ball-milling medium and liquid additive through the in situ method. Results…

Inherent properties of superconducting Bi2Sr2CaCu2O8+x films, such as the high superconducting transition temperature Tc, efficient Josephson coupling between neighboring CuO layers, and fast quasiparticle relaxation dynamics, make them a…

We have fabricated the Fe(Se, Te) superconducting wire by a special process based on a powder-in-tube method. The pure Fe tube plays the role of not only the sheath but also the raw material for synthesizing the superconducting phases. We…

High critical temperature superconductors have zero power consumption and could be used to produce ideal electric power lines. The principal obstacle in fabricating superconducting wires and tapes is grain boundaries-the misalignment of…

We have successfully grown epitaxial, superconducting films of Ba(Fe1-xCox)2As2 (Ba-122)with x ~ 0.1. The films grow without observable correlated defects parallel to the c-axis, as confirmed by TEM. This is also reflected in the absence of…

Nb3Sn superconducting strands are the most practical conductors to generate high magnetic fields (12-16 T), and thus have significant applications in nuclear magnetic resonance (NMR), and great potential for fusion reactors and particle…

The effect of the quality of starting powders on the microstructure and superconducting properties of in-situ processed Fe-sheathed MgB2 tapes has been investigated. Three different types of commercial atomized spherical magnesium powder…

Pinning force data, Fp, of a variety of Fe-based high-Tc superconductors (11-, 111-, 122- and 1111-type) were analyzed by means of a scaling approach based on own experimental data and an extensive collection of literature data. The…

The most effective way to enhance the dissipation-free supercurrent in presence of magnetic field for type II superconductors is the introduction of defects that acts as artificial pinning centres (APCs) for the vortices. For instance, the…

Ex-situ Powder-In-Tube MgB2 tapes prepared with ball-milled, undoped powders showed a strong enhancement of the irreversibility field H*, the upper critical field Hc2 and the critical current density Jc(H) together with the suppression of…

We studied enhanced superconductivity in point contacts (PCs) based on a type-I Weyl semimetal trigonal t-PtBi2 using both normal metal (Ag, Cu, Pt) and ferromagnetic (Fe, Co, Ni) tips by measuring the differential resistance dV/dI(V)…