相关论文: Boiling of the Interface between Two Immiscible Li…
We present an approach to theoretical assessment of the mean specific interface area $(\delta{S}/\delta{V})$ for a well-stirred system of two immiscible liquids experiencing interfacial boiling. The assessment is based on the balance of…
There hardly is a fluid mechanics phenomenon attracting more attention than the impact of a droplet, due to its undeniable beauty, many applications and the numerous challenges it poses. One of the crucial factors turns out to be the…
Manipulating surface topography is one of the most promising strategies for increasing the efficiency of numerous industrial processes involving droplet contact with superheated surfaces. In such scenarios, the droplets may immediately boil…
For well-stirred multiphase fluid systems the mean interface area per unit volume, or "specific interface area" $S_V$, is a significant characteristic of the system state. In particular, it is important for the dynamics of systems of…
Everybody knows that when a liquid is heated, its temperature increases until the moment when it starts to boil. The increase in temperature then stops, all heat being used to transform the liquid into vapor. What is the microscopic origin…
We study heat transfer from a heated nanoparticle into surrounding fluid, using molecular dynamics simulations. We show that the fluid next to the nanoparticle can be heated well above its boiling point without a phase change. Under…
We experimentally investigate the boiling behavior of impacting ethanol drops on a heated smooth sapphire substrate at pressures ranging from P = 0.13 bar to atmospheric pressure. We employ Frustrated Total Internal Reflection (FTIR)…
To understand the boiling crisis mechanism, one can take advantage of the slowing down of boiling at high pressures, in the close vicinity of the liquid-vapor critical point of the given fluid. To preserve conventional bubble geometry, such…
The Leidenfrost effect is a phenomenon in which a liquid, poured onto a surface significantly hotter than the liquid's boiling point, produces a layer of vapor that prevents the liquid from rapid evaporation. Rather than making physical…
Drops of water at room temperature were released in hot oil, which had a temperature higher than that of the boiling point of water. Initially, the drop temperature increases slowly mainly due to heat transfer diffusion; convective heat…
Four results associated with the diffuse-interface model (DIM) for contact lines are reported in this paper. First, a boundary condition is derived, which states that the fluid near a solid wall must have a certain density $\rho_{0}$…
In this paper, a numerical study is conducted to investigate boiling of a cryogen on a solid surface as well as on a liquid surface. Both single mode and multi-mode boiling is reported for boiling on to a solid surface. In case of boiling…
Although ubiquitous in nature and industrial processes, transport processes at the interface during evaporation and condensation are still poorly understood. Experiments have shown temperature discontinuities at the interface during…
The liquid to vapour transition can occur at unexpected conditions in nanopores, opening the door to fundamental questions and new technologies. The physics of boiling in confinement is progressively introduced, starting from classical…
Boiling crisis is the rapid formation of the quasi-continuous vapor film between the heater and the liquid when the heat supply exceeds a critical value. We propose a mechanism for the boiling crisis that is based on the spreading of the…
A hydrophilic liquid, such as water, forms hydrogen bonds with a hydrophilic substrate. The strength and locality of the hydrogen bonding interactions prohibit slip of the liquid over the substrate. The question then arises how the contact…
Transition boiling is an intermediate regime occurring between nucleate boiling, where bubbles at the surface efficiently carry heat away, and film boiling, where a layer of vapor formed over the surface insulates the system reducing heat…
Boiling crisis is a transition between nucleate and film boiling. In this communication we present a physical model of the boiling crisis based on the vapor recoil effect. Our numerical simulations of the thermally controlled bubble growth…
Boiling is a very efficient way to transfer heat from a heater to the liquid carrier. We discuss the boiling crisis, a transition between two regimes of boiling: nucleate and film boiling. The boiling crisis results in a sharp decrease in…
This study deals with a simple pure fluid whose temperature is slightly below its critical temperature and whose density is nearly critical, so that the gas and liquid phases coexist. Under equilibrium conditions, such a liquid completely…