相关论文: Distributed Can-Bus Based Beam Diagnostic System f…
ProtoDUNE-DP is a 6x6x6 m3 liquid argon time-projection-chamber operated at the CERN Neutrino Platform in 2019-2020 as a prototype of the Dual Phase concept for the DUNE Far Detector. The Photon Detection System (PDS) is based on 36 8-inch…
The innermost part of the ATLAS experiment will be a pixel detector containing around 1750 individual detector modules. A detector control system (DCS) is required to handle thousands of I/O channels with varying characteristics. The main…
Decentralized diagnostic testing that is accurate, portable, quantitative, and capable of making multiple simultaneous measurements of different biomarkers at the point-of-need remains an important unmet need in the post-pandemic world.…
The ALICE Collaboration has just finished a major detector upgrade that increases the data-taking rate capability by two orders of magnitude and will allow to collect unprecedented data samples. For example, the analysis input for 1 month…
Restricting bus voltage deviation is crucial for normal operation of multi-bus DC microgrids, yet it has received insufficient attention due to the conflict between two main control objectives in DC microgrids, i.e., voltage regulation and…
The central institute of electronics (ZEA-2) in the Forschungszentrum Juelich (FZJ) has developed a system to scan the response of the photocathode of photomultiplier tubes (PMT). The PMT sits tight on a supporting structure, while a blue…
Sensor signals acquired in the industrial process contain rich information which can be analyzed to facilitate effective monitoring of the process, early detection of system anomalies, quick diagnosis of fault root causes, and intelligent…
In order to interface the DESY fieldbus adapter, SEDAC (SErial Data Acquisition and Control system), a full duplex device driver was developed for the Windows NT, Linux, VxWorks, and Solaris operating systems. Detailed driver development…
A detailed understanding of the dynamic processes of vehicular radio channels is crucial for its realistic modeling. In this paper, we present multipath components (MPCs) tracking results from a channel sounder measurement with 1 GHz…
BPM (Beam Position Measurement) system is one of the most important beam diagnostic instruments in accelerators. A fully digital BPM (DBPM) has been designed for SSRF (Shanghai Synchrotron Radiation Facility). As Analog-to-Digital Converter…
Distributed parameter systems (DPS) are formulated as partial differential equations (PDE). Especially, under time-varying boundary conditions, PDE introduce force coupling. In the case of the flexible stacker crane (STC), nonlinear…
Most of the devices in the SLAC control system are accessed via interface modules in ~450 CAMAC crates. Low-cost controllers in these crates communicate via a SLAC-proprietary bit-serial protocol with 77 satellite control computers…
Our growing ability to tailor healthcare to the needs of individuals has the potential to transform clinical treatment. However, the measurement of multiple biomarkers to inform clinical decisions requires rapid, effective, and affordable…
The setups for precise measurements of the time structure of Nuclotron internal and slowly extracted beams are described in both hardware and software aspects. The CAMAC hardware is based on the use of the standard CAMAC modules developed…
A data acquisition (DAQ) system has been developed which will read out and control calorimeters serving as prototype systems for a future detector at an electron-positron linear collider. This is a modular, flexible and scalable DAQ system…
In this paper, we propose an efficient acquisition scheme for GPS receivers. It is shown that GPS signals can be effectively sampled and detected using a bank of randomized correlators with much fewer chip-matched filters than those used in…
We present a control and measurement setup for superconducting qubits based on Xilinx 16-channel radio-frequency system-on-chip (RFSoC) device. The proposed setup consists of four parts: multiple RFSoC boards, a setup to synchronise every…
The data acquisition system is based on ROOT and waveform digital technology, including neutron detector, waveform digitizer, PCI card, optical fiber, computer, reaction target device, stepper motor, data acquisition software and control…
As the autonomous vehicle industry continues to grow, various companies are exploring the use of aftermarket kits to retrofit existing vehicles with semi-autonomous capabilities. However, differences in implementation of the controller area…
Microwave reflectometry is a non-intrusive plasma diagnostic tool which is widely applied in many fusion devices. In 2014, the microwave reflectometry on Experimental Advanced Superconducting Tokamak (EAST) had been upgraded to measure…