相关论文: Corrector Power Supplies with a DAC Resolution up …

This paper presents a differential 10-bit 2 MS/s successive approximation register (SAR) analog-to-digital converter (ADC) with a precision-improvement technique. The proposed method breaks the direct tradeoff between the capacitive…

The true-differential superconductor on-chip amplifier has complementary outputs that float with respect to chip ground. This improves signal integrity and compatibility with the receiving semiconductor stage. Both source-terminated and…

The purpose of this project was to design and implement a pipeline Analog-to-Digital Converter using 0.35um CMOS technology. Initial requirements of a 25-MHz conversion rate and 8-bits of resolution where the only given ones. Although…

It is known that the estimated energy consumption of digital-to analog converters (DACs) is around 30\% of the energy consumed by analog-to-digital converters (ADCs) keeping fixed the sampling rate and bit resolution. Assuming that…

High resolution analog to digital converters (ADCs) are conventionally used at the receiver terminals to store an accurate digital representation of the received signal, thereby allowing for reliable decoding of transmitted messages.…

In future high-capacity wireless systems based on mmWave or massive multiple input multiple output (MIMO), the power consumption of receiver Analog to Digital Converters (ADC) is a concern. Although hybrid or analog systems with fewer ADCs…

High sampling speed can be achieved using multiple Analog-to-Digital Converters (ADCs) based on the Time-Interleaving A/D Conversion (TIADC) technique. Various types of methods were proposed to correct the mismatch errors among parallel ADC…

The power consumption of high-speed, high-resolution analog to digital converters (ADCs) is a limiting factor in implementing large-bandwidth mm-wave communication systems. A mitigating solution, which has drawn considerable recent…

We consider a fully digital massive multiple-input multiple-output architecture with low-resolution analog-to-digital/digital-to-analog converters (ADCs/DACs) at the base station (BS) and analyze the performance trade-off between the number…

This paper presents a 17 bit analogue-to-digital converter that incorporates mismatch and quantisation noise-shaping techniques into an energy-saving 10 bit successive approximation quantiser to increase the dynamic range by another 42 dB.…

Low-resolution analog-to-digital converters (ADCs) have emerged as a promising technology for reducing power consumption and complexity in massive multiple-input multiple-output (MIMO) systems while maintaining satisfactory spectral and…

Switched-Capacitor Converters (SCC) suffer from a fundamental power loss deficiency which make their use in some applications prohibitive. The power loss is due to the inherent energy dissipation when SCC operate between or outside their…

A high-precision charge measurement can be achieved by the area integration of a digitized quasi-Gaussian signal after the signal passes through the shaper and analog-to-digital converter (ADC). The charge measurement contains an error due…

The design and measurement results of ultra-low power, fast 10-bit Successive Approximation Register (SAR) Analog-to-Digital Converter (ADC) prototypes in 65 nm CMOS technology are presented. Eight prototype ADCs were designed using two…

Transistor random mismatch continuously poses challenges for analog/RF circuit design for achieving high accuracy and high yield as the process technology advances. Existing statistical element selection (SES) design method can improve…

Optical Ising machines have emerged as a promising dynamical hardware solver for computational hard optimization problems. These Ising machines typically require an optical modulator to represent the analog spin variables of these problems.…

Energy-efficient signal processing systems require estimation methods operating on data collected with low-complexity devices. Using analog-to-digital converters (ADC) with $1$-bit amplitude resolution has been identified as a possible…

In this contribution, it is proposes to limit the quantization search space of a successive approximation analog-to-digital converter through an analytic derivation of maximum possible sample-to-sample variation. The presented example…

We consider the downlink of a massive multiuser (MU) multiple-input multiple-output (MIMO) system in which the base station (BS) is equipped with low-resolution digital-to-analog converters (DACs). In contrast to most existing results, we…

D-Wave only guarantees to support coefficients with 4 to 5 bits of resolution or precision. This paper describes a method to extend the functionality of the D-Wave to solve problems that require the support of higher precision coefficients.