相关论文: Theoretical study of O adlayers on Ru(0001)

The formation of chemisorbed O-phases on Ru(0001) by exposure to O_2 at low pressures is apparently limited to coverages Theta <= 0.5. Using low-energy electron diffraction and density functional theory we show that this restriction is…

Oxygen adsorption onto Ru (10 bar 1 0) results in the formation of two ordered overlayers, i.e. a c(2 times 4)-2O and a (2 times 1)pg-2O phase, which were analyzed by low-energy electron diffraction (LEED) and density functional theory…

Using density-functional theory, we predict that the oxidation of the Ru(0001) surface proceeds via the accumulation of sub-surface oxygen in two-dimensional islands between the first and second substrate layer. This leads locally to a…

The dynamical properties of the high-density Ru(001)-(1$\times$1)-O phase has been investigated by a combined high-resolution electron energy loss spectroscopy and density functional theory study. Due to a strong static outward relaxation…

The atomic surface and interface structure of bare and metal-coated ZnO(0001) Zn-polar wafers were investigated via surface x-ray diffraction. All bare samples showed the presence of a (1x1) overlayer of oxygen atoms located at the on-top…

Atomic oxygen adsorption on the Mo(112) surface has been investigated by means of first-principles total energy calculations. Among the variety of possible adsorption sites it was found that the bridge sites between two Mo atoms of the…

The success of density functional theory for the description of the adsorption of atoms on surfaces is well established, and based on recent calculations using gradient corrections, it has been shown that it also describes well the…

Knowledge of the atomic geometry of a surface is a prerequisite for any detailed understanding of the surface's electronic structure and chemical properties. Previous studies have convincingly demonstrated that density functional theory…

Experiments performed at high gas partial pressures have demonstrated that the kinetics of the CO oxidation reaction at Ru(0001) is different and somewhat anomalous compared to that over other transition metal surfaces and, in particular,…

In recent years due to improvements in calculation methods and increased computer power, it has become possible to perform first-principles investigations for ``simple'' chemical reactions at surfaces. We have carried out such studies for…

First principles density functional calculations are used to study the early oxidation stages of the Mg(0001) surface for oxygen coverages 1/16 <= Theta <= 3 monolayers. It is found that at very low coverages O is incorporated below the…

We report results of density-functional theory calculations on the structural, magnetic, and electronic properties of (1x1)-structures of Co on Cu(001) for coverages up to two monolayers. In particular we discuss the tendency towards phase…

To help provide insight into the remarkable catalytic behavior of the oxygen/silver system for heterogeneous oxidation reactions, purely sub-surface oxygen, and structures involving both on-surface and sub-surface oxygen, as well as…

Using density-functional theory (DFT) we investigate the incorporation of oxygen directly below the Rh(111) surface. We show that oxygen incorporation will only commence after nearly completion of a dense O adlayer (\theta_tot = 1.0…

Using density-functional theory (DFT) we calculate the Gibbs free energy to determine the lowest-energy structure of a RuO_2(110) surface in thermodynamic equilibrium with an oxygen-rich environment. The traditionally assumed stoichiometric…

Pd(111) has recently been shown to exhibit a propensity to form a sub-nanometer thin surface oxide film already well before a full monolayer coverage of adsorbed O atoms is reached on the surface. Aiming at an atomic-scale understanding of…

The structural, vibrational, energetic and electronic properties of hydrogen at the stoichiometric RuO2(110) termination are studied using density functional theory. The oxide surface is found to stabilize both molecular and dissociated H2.…

We present a density-functional theory study addressing the energetics and electronic structure properties of isolated oxygen adatoms at the SrTiO3(001) surface. Together with a surface lattice oxygen atom, the adsorbate is found to form a…

We demonstrate a method for synthesizing large scale single layer graphene by thermal annealing of ruthenium single crystal containing carbon. Low energy electron diffraction indicates the graphene grows to as large as millimeter dimensions…

The structure of the ultimately-thin crystalline allotrope of silicon oxide, prepared onto a ruthenium surface, is unveiled down to atomic scale with chemical sensitivity, thanks to high resolution scanning tunneling microscopy and first…