相关论文: Novel procedure to prepare cadmium stannate films …
Selenium has resurged as a promising photovoltaic material in solar cell research due to its wide direct bandgap of 1.95 eV, making it a suitable candidate for a top cell in tandem photovoltaic devices. However, the optoelectronic quality…
Sol-gel spin coating technique was employed to synthesize CuO thin films at 1500 rpm, 2200 rpm and 2400 rpm for 30 seconds, and subsequently annealed at 150-550{\deg}C for 1 hour. Multi-layered CuO thin films with 3 and 5 layers were…
Thin films of thulium and ytterbium-doped titanium oxide were grown by metal-organic spray pyrolysis deposition from titanium(IV)oxide bis(acetylacetonate), thulium(III) tris(2,2,6,6-tetramethyl-3,5-heptanedionate) and ytterbium(III)…
CdTe and CdS are emerging as the most promising materials for thin film photovoltaics in the quest of the achievement of grid parity. The major challenge for the advancement of grid parity is the achievement of high quality at the same time…
Physical vapor high-temperature deposition of CdTe thin films is one of the main methods for preparing high-efficiency CdTe solar cells, but high-temperature deposition also has an impact on the internal structure of the film. The…
We report the development of broadband solar absorber coatings based on titanium suboxide composite thin films on aluminium substrates. The films are fabricated via scalable DC magnetron sputtering using a Ti target, followed by…
Vanadium oxide films and fibers have been fabricated by the acetylacetonate sol-gel method followed by annealing in wet nitrogen. The samples are characterized by X-ray diffraction and electrical conductivity measurements. The effects of a…
Zinc telluride (ZnTe) thin films have special semiconducting characteristics that make them very promising for a broad range of optoelectronic applications. In this work, a novel approach for synthesizing ZnTe thin films by spin coating…
CdS samples were synthesized on amorphous glass and conductive glass substrates at room temperature using spin coating technique and subsequently annealed at five different temperatures in air for one hour. The speed and time of spin…
CdS thin film samples were fabricated using spin coating technique on normal glass and conductive glass substrates and annealed at different temperatures. According to the XRD patterns of films prepared on normal glass substrates,…
Thermochromic vanadium dioxide thin films have attracted much attention recently for constructing variable-emittance coatings upon its insulator-metal phase transition for dynamic thermal control. However, fabrication of high-quality…
Cu added CdS films were synthesized using spin coating technique at different spin speeds for different time durations. Films were subsequently annealed at different temperatures for different time periods in air to crystallize the phase of…
The ability to control porosity in oxide thin films is one of the key factors that determine their properties. Despite the abundance of dry processes for the synthesis of oxide porous layers, the high porosity range is typically achieved by…
Thin aluminum oxide films were deposited by a new and simple physicochemical method called chemical liquid phase deposition (CLD) on semiconductor materials. Aluminum sulfate with crystallized water and sodium bicarbonate were used as…
Plasma enhanced atomic layer deposition was used to deposit thin films of Ga2O3 on to c-plane sapphire substrates using triethylgallium and O2 plasma. The influence of substrate temperature and plasma processing parameters on the resultant…
We report a novel method for depositing patterned dielectric layers with sub-micron features using atomic layer deposition (ALD). The patterned films are superior to sputtered or evaporated films in continuity, smoothness, conformality, and…
Integration of thin-film oxide piezoelectrics on glass is imperative for the next generation of transparent electronics to attain sensing and actuating functions. However, their crystallization temperature (above 650 {\deg}C) is…
Graded composition CdxZn1-xTe films were prepared by growing several alternate layers of CdTe and ZnTe by the Isothermal Close Space Sublimation technique. The thickness of both kinds of layers was modified along the structure to produce an…
This study focuses on enhancing the electrical and thermoelectric properties of tungsten trioxide (WO$_3$) thin films using the spray pyrolysis technique. Three samples, namely A$_1$, A$_2$, and A$_3$, were prepared by depositing the films…
We report the synthesis of polycrystalline (poly)-SiGe alloy thin films through solid state reaction of Si/Ge multilayer thin films on Si and glass substrates at low temperature of 500 {\deg}C. The pristine thin film was deposited using…