相关论文: Dealloying by peritectic melting
When a swollen, thermoresponsive polymer gel is heated in a solvent bath, it expels solvent and deswells. When this heating is slow, deswelling proceeds homogeneously, as observed in a toroid-shaped gel that changes volume whilst…
Dewetting of a binary alloy thin film is studied using a continuum many-parameter model that accounts for the surface and bulk diffusion, the bulk phase separation, the surface segregation and the particles formation. Analytical solution is…
The evolution of the atomic structures of the combinatorial library of Sm-substituted thin film BiFeO3 along the phase transition boundary from the ferroelectric rhombohedral phase to the non-ferroelectric orthorhombic phase is explored…
The instability, dynamics and morphological transitions of patterns in thin liquid films on periodic striped surfaces (consisting of alternating less and more wettable stripes) are investigated based on 3-D nonlinear simulations that…
Liquid drops slide more slowly over soft, deformable substrates than over rigid solids. This phenomenon can be attributed to the viscoelastic dissipation induced by the moving wetting ridge, which inhibits a rapid motion, and is called…
The effects of thermal coupling between two thin liquid layers, separated by a gas layer, are discussed. The liquid layers undergo long-wavelength instabilities driven by gravitational and thermocapillary stresses. To study the dynamics,…
Understanding how a flow turns into an amorphous solid is a fundamental challenge in statistical physics, during which no apparent structural ordering appears. In the athermal limit, the two states are connected by a well-defined jamming…
The physics of disordered media, from metallic glasses to colloidal suspensions, granular matter and biological tissues, offers difficult challenges because it often occurs far from equilibrium, in materials lacking symmetries and evolving…
We simulate solidification in a narrow channel through the use of a phase-field model with an adaptive grid. In different regimes, we find that the solid can grow in fingerlike steady-state shapes, or become unstable, exhibiting unsteady…
Liquid migration in active soft solids is a very common phenomenon in Nature at different scales: from cells to leaves. It can be caused by mechanical as well as chemical actions. The work focuses on the migration of liquid provoked by…
Based on classical concept, solidification of alloys is a direct transition from liquid phase to solid phase, by which dendrites and dendritic segregation are produced. Through in-situ and real time morphology observation and XRD test…
Nano-scale eutectics, such as rapid solidified Al-Si, exhibit enhanced yield strength and strain hardening but plasticity is limited by cracking of the hard phase (Si). Mechanisms that may suppress cracking and enable plastic co-deformation…
Close to the triple point, the surface of ice is covered by a thin liquid layer (so-called quasi-liquid layer) which crucially impacts growth and melting rates. Experimental probes cannot observe the growth processes below this layer, and…
We report epitaxial growth of $\beta$-Ag2Te thin films by molecular beam epitaxy. $\beta$-Ag2Te, recently identified as a topological insulator, was grown by depositing Ag on InP substrate at room temperature followed by Te supply at…
What characterises a solid is its way to respond to external stresses. Ordered solids, such crystals, display an elastic regime followed by a plastic one, both well understood microscopically in terms of lattice distortion and dislocations.…
It is shown how the combination of atomic deposition and nonlinear diffusion may lead, below a critical temperature, to the growth of nonuniform layers on a substrate. The dynamics of such a system is of the Cahn-Hilliard type, supplemented…
A Landau-Ginsburg-Devonshire-type nonlinear phenomenological theory is presented, which enables the thermodynamic description of dense laminar polydomain states in epitaxial ferroelectric thin films. The theory explicitly takes into account…
Delamination of thin films from the supportive substrates is critical issues in thin film industry and technology. The emergent two-dimensional materials, atomic layered materials, such as transition metal dichalcogenides are highly…
When a solid substrate is withdrawn from a bath of simple, partially wetting, nonvolatile liquid, one typically distinguishes two regimes, namely, after withdrawal the substrate is macroscopically dry or homogeneously coated by a liquid…
A continuous surface wetting transition, pinned to a solid/liquid/liquid/vapor tetra coexistence point, is studied by x-ray reflectivity in liquid Ga-Bi binary alloys. The short-range surface potential is determined from the measured…