相关论文: A 40 GHz Low-Power Variable-Gain Low Noise Amplifi…

Next-generation cellular systems require low-power mm-wave phased-array ICs. Variable-gain LNAs (VG-LNAs) are key blocks enabling reduced hardware complexity, performance improvement and added functionalities. This paper reports a low-power…

This paper presents the analysis, design, fabrication, and measurement of an integrated low-noise amplifier (LNA) implemented using a 130 nm CMOS technology, operating in the 2.4 GHz band. The LNA is a crucial component in the performance…

Next-generation (5G/6G) wireless systems demand low-power mm-wave phased-array ICs. Variable-gain LNAs (VGLNAs) are key building blocks enabling hardware complexity reduction, performance enhancement and functionality extension. This paper…

A low-noise amplifier (LNA) amplifies a very low-power signal without significantly degrading its signal-to-noise ratio. This paper provides the design of a linear low noise amplifier with the transistor BFP 640 using bilateral approach…

This paper presents a low-noise amplifier (LNA) that was developed for a new radio telescope comprised of 512 parabolic dish antennas. The LNA closely interfaces to a custom-made antenna feed with an impedance co-designed to provide noise…

Noise level frequently set the basic limit on the smallest signal. New noise reduction technology and amplifiers voltage-noise density, yet still offer high speed, high accuracy, and low power solution. Low noise amplifiers always play a…

This paper studies an architecture with digitally controllable gain and power consumption to mitigate the impact of process variations on CMOS low-noise amplifiers (LNAs). A \SI{130}{nm}, \SI{1.2}{V} LNA implementing the proposed…

One of the major challenges in communication, radar, and electronic warfare receivers arises from nearby device interference. The paper presents a 2-6 GHz GaN LNA front-end with onboard sensing, processing, and feedback utilizing…

This paper demonstrates designing and developing of an Ultra-Low Noise Amplifier which should potentially increase the sensitivity of the existing Magnetic Resonance Imaging (MRI) systems. The Design of the LNA is fabricated and…

To achieve the low noise and wide bandwidth required for millimeter wavelength astronomy applications, superconductor-insulator-superconductor (SIS) mixer based receiver systems have typically been used. This paper investigates the…

Large-scale superconducting quantum computers require massive numbers of high-performance cryogenic low-noise amplifiers (cryo-LNA) for qubit readout. Here we present a C-Band monolithic microwave integrated circuit (MMIC) cryo-LNA for this…

In high-performance RF transceivers the thrust of has been on lower noise LNAs and high-power high-speed PAs. The performance trade-off has forced many solutions to have the LNA and PA on a separate die compared to the rest of baseband.…

This paper presents a compact low-power, low-noise bioamplifier for multi-channel electrode arrays, aimed at recording action potentials. The design we put forth attains a notable decrease in both size and power consumption. This is…

The paper describes the project, implementation and test of a C-band (5GHz) Low Noise Amplifier (LNA) using new low noise Pseudomorphic High Electron Mobility Transistors (pHEMTS) from Avago. The amplifier was developed to be used as a cost…

A low power cascode SiGe BiCMOS low noise amplifier (LNA) with current reuse and zero-pole cancellation is presented for ultra-wideband (UWB) application. The LNA is composed of cascode input stage and common emitter (CE) output stage with…

As the Internet of Things (IOT) is growing rapidly, there is an emerging need to facilitate development of IOT devices in the design cycle while optimized performance is obtained in the field of operation. This paper develops…

With the extreme scaling, active devices in both CMOS and BiCMOS technologies have reached outstanding ft/fmax, enabling an ever-increasing number of existing and emerging applications in the microwave and millimeter wave (mm-wave)…

This study undertakes the theoretical design, CAD modeling, realization, and performance analysis of a microwave low-noise amplifier (LNA) which has been accurately developed for operation at 3.0 GHz (S-band). The objective of this research…

This paper investigates the impact of technological constraints on passive elements in the design of inductively degenerated CMOS low-noise amplifiers (LNAs). A theoretical analysis is combined with circuit simulations in a 130-nm CMOS…

In this paper a new design of MMIC based LNA is outlined. This design uses a discrete 100-nm InP HEMT placed in front of an existing InP MMIC LNA to lower the overall noise temperature of the LNA. This new approach known as the Transistor…