相关论文: Growth and characterization of ultrathin cobalt fe…

Thin films of Fe(1+delta)Se(1-x)Te(x) (delta ~ 0.18 & x ~ 0.5) have been successfully grown on (100) oriented single crystalline SrTiO3 and LaAlO3 substrates by pulsed laser deposition. The crystal structure was characterized by x-ray…

MnGe has been grown as a thin film on Si(111) substrates by molecular beam epitaxy. A 10 \AA\ layer of MnSi was used as seedlayer in order to establish the B20 crystal structure. Films of a thickness between 45 and 135 \AA\ have been…

Epitaxial thin films of the highly spin polarized Heusler compound Co2Cr0.6Fe0.4Al are deposited by dc magnetron sputtering. It is shown by XRD and TEM investigations how the use of an Fe buffer layer on MgO(100) substrates supports the…

This work reports the peculiar properties of a graphene film prepared by the chemical vapor deposition (CVD) of ethylene in high vacuum on a well oriented and carefully cleaned Pt(111) crystal surface maintained at high temperature. In-situ…

The heteroepitaxial growth of Re (0001) films on Nb (110) surfaces has been investigated. Nb/Re bilayers were grown on A-plane sapphire -- alpha-Al2O3 (11-20) -- by molecular beam epitaxy. While Re grew with a (0001) surface, the in-plane…

Epitaxial MgB2 thick films were grown on Al2O3 substrates at 600 oC by using the hybrid physical chemical vapor deposition (HPCVD) technique. In order to obtain a high magnesium vapor pressure around the substrates, we used a special…

FePt/Fe3O4 nanoparticles can be used as building blocks to obtain, upon thermal annealing, magnetic nanocomposites with combined magnetic properties. Although the pre- and post-annealed samples are usually well characterized, a detailed…

We demonstrate the growth of Co-doped BaFe2As2 (Ba-122) thin films on AEF2 (001) (AE: Ca, Sr, Ba) single crystal substrates using pulsed laser deposition. All films are grown epitaxially despite of a large misfit of -10.6% for BaF2…

Antiferromagnetic kagome metal FeGe has attracted tremendous attention in condensed matter physics due to the charge density wave (CDW) being well below its magnetic transition temperature. Up to now, numerous works on kagome FeGe have been…

We have investigated epitaxial graphene films grown on SiC(0001) by annealing in an atmosphere of Ar instead of vacuum. Using AFM and LEEM we observe a significantly improved surface morphology and graphene domain size. Hall measurements on…

Self assembly on suitably chosen substrates is a well exploited root to control the structure and morphology, hence magnetization, of metal films. In particular, the Cu3Au(001) surface has been recently singled out as a good template to…

We have grown lead iron niobate thin films with composition Pb(Fe1/2Nb1/2)O3 (PFN) on (0 0 1) SrTiO3 substrates by pulsed laser deposition. The influence of the deposition conditions on the phase purity was studied. Due to similar…

We report the deposition of thin Co$_2$FeSi films by RF magnetron sputtering. Epitaxial (100)-oriented and L2$_1$ ordered growth is observed for films grown on MgO(100) substrates. (110)-oriented films on Al$_2$O$_3$(110) show several…

NbN films are grown on c-plane sapphire substrates by molecular beam epitaxy. The structural and superconducting properties of the film are characterized to demonstrate that growth parameters such as substrate temperature and active…

We grow Fe film on (4 by 2)-GaAs(100) at low temperature, (~ 130 K) and study their chemical structure by photoelectron spectroscopy using synchrotron radiation. We observe the effective suppression of As segregation and remarkable…

Atomic layer deposition of ultrathin HfO2 on unmodified graphene from HfCl4 and H2O was investigated. Surface RMS roughness down to 0.5 nm was obtained for amorphous, 30 nm thick hafnia film grown at 180 degrees C. HfO2 was deposited also…

Enhanced (001) anomalous scattering by YBa2Cu3O7-d 50 nm films on SrTiO3 substrates with and without a grain boundary versus temperature is interpreted using crystallographic weights to distinguish it from total electron yield and…

Strain-engineering is a powerful means to tune the polar, structural, and electronic instabilities of incipient ferroelectrics. KTaO3 is near a polar instability and shows anisotropic superconductivity in electron-doped samples. Here, we…

We present a study on the crystallization process of undoped and Ta doped TiO2 amorphous thin films. In particular, the effect of ultra-fast annealing treatments in environments characterized by different oxygen concentrations is…

Spin coating technique was employed to fabricate CuO films at different spin speeds for different time duration, and they were annealed at different temperatures for different time durations in air. These thin films were characterized using…