相关论文: Deep insights into the local structure of amorphou…
Scaling up superconducting quantum circuits based on transmon qubits necessitates substantial enhancements in qubit coherence time. Among the materials considered for transmon qubits, tantalum (Ta) has emerged as a promising candidate,…
Crystalline wurtzite zinc oxide (w-ZnO) can be used as a wide band gap semiconductor for light emitting devices and for transparent or high temperature electronics. The use of amorphous zinc oxide (a-ZnO) can be an advantage in these…
Electrical and optical properties of amorphous vanadium oxide thin films obtained by electrochemical anodic oxidation are studied. It is shown that under cathodic polarization the hydrogen insertion into vanadium oxide from an electrolyte…
Nanostructured TiO2 thin films were prepared by pulsed laser deposition (PLD) on indium doped tin oxide (ITO) substrates. Results from X-ray photoelectron spectroscopy (XPS) show that Ti 2p core level peaks shift toward the lower binding…
Titanium dioxide is one of the most widely used wide bandgap materials. However, the TiO2 deposited on a substrate is not always transparent leading to a loss in efficiency of the device, especially, the photo response. Herein, we show that…
This work reports the fabrication and characterization of high-quality tungsten-doped vanadium dioxide (WxV1-xO2, x = 0~3 at. %) by thermal oxidation of sputtered tungsten-vanadium alloyed thin films with different atomic percentages and…
Compared to the widely investigated crystalline polymorphs of gallium oxide (Ga2O3), knowledge about its amorphous state is still limited. With the help of a machine-learning interatomic potential, we conducted large-scale atomistic…
Amorphous silica (a-SiO2) exhibits unique thermo-mechanical behaviors that set it apart from other glasses. However, there is still limited understanding of how this mechanical behavior is related to the atomic structure and to the…
We report the development of broadband solar absorber coatings based on titanium suboxide composite thin films on aluminium substrates. The films are fabricated via scalable DC magnetron sputtering using a Ti target, followed by…
Two-dimensional topological insulators (2DTIs) or quantum spin Hall insulators are attracting increasing attention due to their potential applications in next-generation spintronic devices. Despite their promising prospects, realizable…
Synthesis of rationally designed nanostructured materials with optimized mechanical properties, e.g., high strength with considerable ductility, requires rigorous control of diverse microstructural parameters including the mean size, size…
X-ray photoelectron spectroscopy (XPS) and resonant x-ray emission spectroscopy (RXES) measurements of pellet and thin film forms of TiO$_2$ with implanted Fe ions are presented and discussed. The findings indicate that Fe-implantation in a…
In the present work, HfO2 thin film (100nm) has been deposited by sputtering technique and annealed at various temperatures ranging from 400 to 1000\degree (in step of 200 \degree) in O2 ambient for 10 min. The samples have been…
For materials near the phase boundary between weak and strong topological insulators (TIs), their band topology depends on the band alignment, with the inverted (normal) band corresponding to the strong (weak) TI phase. Here, taking the…
We present results of electrical conduction studies of Ti/TiOx/Ti planar structures prepared by tip-induced local anodic oxidation (LAO) of titanium thin films. The prepared structures have shown almost linear I-V curves at temperatures…
The structural properties of Thallium (III) oxide (Tl2O3) have been studied both experimentally and theoretically under compression at room temperature. X-ray powder diffraction measurements up to 37.7 GPa have been complemented with ab…
Supported carbon nanosheets and carbon nanotubes served as sacrificial templates for preparing spacious TiO2 photocatalytic thin films. Amorphous TiO2 was deposited conformally on the carbonaceous template material by atomic layer…
We demonstrate waveguide-coupled titanium dioxide (TiO2) racetrack resonators with loaded quality factors of 2x10^4 for the visible wavelengths. The structures were fabricated in sputtered TiO2 thin films on oxidized silicon substrates…
A template-free process for the synthesis of nanocrystalline TiO2 hierarchical microstructures by reactive Pulsed Laser Deposition (PLD) is here presented. By a proper choice of deposition parameters a fine control over the morphology of…
We explore the growth of {\alpha}-Ta thin films ranging from ultra-thin (2 nm) to thick (250 nm) films grown by sputter epitaxy on c-plane sapphire substrates. We utilized 100 W power with a 32 mTorr sputter pressure at 650 {\deg} substrate…