相关论文: A new constitutive model for tetragonal energetic …

We present a multiscale model bridging length and time scales from molecular to continuum levels with the objective of predicting the yield behavior of amorphous glassy polyethylene (PE). Constitutive parameters are obtained from molecular…

We derive a continuum-level plasticity model for polycrystalline materials in the high energy density regime, based on a single dislocation density and single mobility mechanism, with an evolution model for the dislocation density. The…

The elasticity tensor that describes the elastic response of a material to external forces is among the most fundamental properties of materials. The availability of full elasticity tensors for inorganic crystalline compounds, however, is…

In this paper we present a new general framework for anisotropic elastoplasticity at large strains. The new framework presents the following characteristics: (1) It is valid for non-moderate large strains, (2) it is valid for both elastic…

The tetragonal states produced by isotropic pseudomorphic epitaxial strain in the (001) plane on a tetragonal phase of a crystal are calculated for V, Ti, Rb, Li, K, Sr from first-principles electronic theory. It is shown that each metal…

In this paper we present a thermodynamically consistent material model which is capable of modelling ductile-to brittle failure mode transition in ductile material undergoing deformations at high strain rates, and demonstrate the…

We compare the macroscopic and the local plastic behavior of a model amorphous solid based on two radically different numerical descriptions. On the one hand, we simulate glass samples by atomistic simulations. On the other, we implement a…

Tensile creep tests, tensile relaxation tests and a tensile test with a constant rate of strain are performed on injection-molded isotactic polypropylene at room temperature in the vicinity of the yield point. A constitutive model is…

Elasto-plastic models are among the most successful ways to study the critical properties of the plastic yielding transition of amorphous solids. Typically these models are studied under a condition of constant transition rates from one…

A simple and popular constitutive model used to describe the compressional strength of a consolidating strongly cohesive particulate gel is tested further with new experimental data. Strong cohesive particulate gels have variously been…

Hyperelastic materials models are well established to describe the non-linear stress-strain relations of elastomers. In this paper, a polyurethane adhesive is considered as an exemplary material and subjected to tensile, compressive and…

We investigate the presence of topological twistons in crystalline polyethylene. We describe crystalline polyethylene with a model that couples the torsional and longitudinal degrees of freedom of the polymeric chain by means of a system of…

The objective of this work is to assess computationally efficient coarse-grained plasticity models against high-fidelity crystal plasticity simulations for magnesium polycrystals over a wide range of textures and grain sizes. A basic…

Using molecular dynamics simulations we study the thermodynamic behavior of a single-component covalent material described by the recently proposed Environment-Dependent Interatomic Potential (EDIP). The parameterization of EDIP for silicon…

In order to enhance the modeling of metallic materials behavior in non proportional loadings, a modification of the classical elastic-plastic models including distortion of the yield surface is proposed. The new yield criterion uses the…

The high cost of density functional theory has hitherto limited the ab initio prediction of equation of state (EOS). In this article, we employ a combination of large scale computing, advanced simulation techniques, and smart data science…

This contribution investigates the extension of the microplane formulation to the description of transversely isotropic materials such as shale rock, foams, unidirectional composites, and ceramics. Two possible approaches are considered: 1)…

We propose a nonlinear elasto-plastic model, for which a specific class of hyperbolic elasticity arises as a straight consequence of the yield criterion invariance on the plasticity level. We superimpose this nonlinear elastic (or…

We develop an energy-landscape based elasto-plastic model to understand the behaviour of amorphous solids under uniform and cyclic shear. Amorphous solids are modeled as being composed of mesoscopic sub-volumes, each of which may occupy…

Almost all the polymer crystals have several polymorphic modifications. Their structure and existence conditions, as well as transitions between them are not understood even in the case of the 'model' polymer polyethylene (PE). For analysis…