相关论文: Joint RFI Mitigation and Radar Echo Recovery for O…
Radio frequency interference (RFI) mitigation is critical to the proper operation of ultra-wideband (UWB) radar systems since RFI can severely degrade the radar imaging capability and target detection performance. In this paper, we address…
We consider the problem of range-Doppler imaging using one-bit automotive LFMCW1 or PMCW radar that utilizes one-bit ADC sampling with time-varying thresholds at the receiver. The one-bit sampling technique can significantly reduce the cost…
In ultra-wideband (UWB) communication systems with impulse radio (IR) modulation, the bandwidth is usually 1GHz or more. To process the received signal digitally, high sampling rate analog-digital-converters (ADC) are required. Due to the…
This paper presents an overview of methods for mitigating radio frequency interference (RFI) in radio science data. The primary purpose of mitigation is to assist observatories to take useful data outside frequency bands allocated to the…
Radio frequency interference (RFI) have been an enduring concern in radio astronomy, particularly for the observations of pulsars which require high timing precision and data sensitivity. In most works of the literature, RFI mitigation has…
Radio Frequency Interference (RFI), the presence of artificial and/or terrestrial signals in astronomical data, poses a great challenge to the search for pulsars and radio transients, such as Rotating Radio Transients (RRATs) and Fast Radio…
This paper presents a novel narrowband interference (NBI) mitigation scheme for SC-FDMA systems. The proposed NBI cancellation scheme exploits the frequency domain sparsity of the unknown signal and adopts a low complexity Bayesian sparse…
Radio frequency interference (RFI) is the principal factor limiting the sensitivities of radio telescopes, particularly at frequencies below 1 GHz. I present a conceptually new approach to mitigation of RFI in interferometric data. This has…
We study the problem of jointly sparse support recovery with 1-bit compressive measurements in a sensor network. Sensors are assumed to observe sparse signals having the same but unknown sparse support. Each sensor quantizes its measurement…
One of the challenges in spaceborne synthetic aperture radar (SAR) is modeling and mitigating radio frequency interference (RFI) artifacts in SAR imagery. Linear frequency modulated (LFM) signals have been commonly used for characterizing…
Because of the denser active use of the spectrum, and because of radio telescopes higher sensitivity, radio frequency interference (RFI) mitigation has become a sensitive topic for current and future radio telescope designs. Even if quite…
With the installation of next-generation phased array feed (PAF) receivers on radio telescopes, there is an urgent need to develop effective and computationally efficient radio frequency interference (RFI) mitigation methods for large-scale…
Correlation-based techniques used for frame synchronization can suffer significant performance degradation over multi-path frequency-selective channels. In this paper, we propose a joint frame synchronization and channel estimation (JFSCE)…
The search for extraterrestrial intelligence (SETI) commensal surveys aim to scan the sky to detect technosignatures from extraterrestrial life. A major challenge in SETI is the effective mitigation of radio frequency interference (RFI), a…
This paper considers the problem of reconstructing sparse or compressible signals from one-bit quantized measurements. We study a new method that uses a log-sum penalty function, also referred to as the Gaussian entropy, for sparse signal…
Radio frequency interference (RFI) is a persistent contaminant in terrestrial radio astronomy. While new radio interferometers are becoming operational, novel sources of RFI are also emerging. In order to strengthen the mitigation of RFI in…
One-bit sampling has emerged as a promising technique in multiple-input multiple-output (MIMO) radar systems due to its ability to significantly reduce data volume and processing requirements. Nevertheless, current detection methods have…
For many practical applications in wireless communications, we need to recover a structured sparse signal from a linear observation model with dynamic grid parameters in the sensing matrix. Conventional expectation maximization (EM)-based…
One-bit compressed sensing (1bCS) addresses the recovery of sparse signals from highly quantized measurements, retaining only the sign of each linear measurement. In the support recovery setting, the goal is to identify $\text{supp}(x)$,…
Based on $\alpha$-stable random projections with small $\alpha$, we develop a simple algorithm for compressed sensing (sparse signal recovery) by utilizing only the signs (i.e., 1-bit) of the measurements. Using only 1-bit information of…