相关论文: Improvement of the Standard Characterization Metho…
Accurate determination of three types of losses (dielectric, elastic and piezoelectric) in piezoelectric materials is critical, since they are closely related to the performance of high-power piezoelectric devices. The Standard k33 mode has…
The standard method to determine physical parameters of piezoceramics, established by IEEE, has been utilized for decades by the number of researchers, yet it omits presence of important loss factors and possesses serious deficits that…
The properties of dielectric and piezoelectric oxides are determined by their processing history, crystal structure, chemical composition, microstructure, dopants (or defect) distribution, and defect kinetics. These materials are essential…
The major resolution-limiting factor in cryoelectron microscopy of unstained biological specimens is radiation damage by the very electrons that are used to probe the specimen structure. To address this problem, an electron microscopy…
A special aspect of parameter identification in finite-strain elasto-plasticity is considered. Namely, we analyze the impact of the measurement errors on the resulting set of material parameters. In order to define the sensitivity of…
We propose an empirical method for identifying low damped modes and corresponding mode shapes using frequency measurements from a Wide Area Monitoring System. The method consists of two main steps: Firstly, Complex Principal Component…
In this work, a new methodology for comparing high power performance of different piezoelectric materials is presented. When comparing high power performance of piezoelectric materials of varying compositions and vibration modes, there…
In this paper, we consider the intensity-based inversion method (IIM) for quantitative material parameter estimation in quasi-static elastography. In particular, we consider the problem of estimating the material parameters of a given…
Recent developments in piezoelectric films have heightened the need for the reliable methods to correctly characterize their piezoelectric coefficients. Here, we demonstrate that capacitive displacement method can be used to determine…
In this work, we define a practical identifiability criterion, (e, q)-identifiability, based on a parameter e, reflecting the noise in observed variables, and a parameter q, reflecting the mean-square error of the parameter estimator. This…
In quantum information processing quantum operations are often processed alongside measurements which result in classical data. Due to the information gain of classical measurement outputs non-unitary dynamical processes can take place on…
This article presents new immersed finite element (IFE) methods for solving the popular second order elliptic interface problems on structured Cartesian meshes even if the involved interfaces have nontrivial geometries. These IFE methods…
A method for modeling the full steady-state and small-signal behavior of practical capacitive structures, such as metal-insulator-metal capacitors, diodes, and transistors, is presented. Simple lumped element models fail to properly…
A class of quasi-distribution evaluation criteria based on piecewise Bezier curves is proposed to address the issue of the inability to objectively evaluate finite element models. During the optimization design of mechanical parts, finite…
The goal of quantitative elastography is to identify biomechanical parameters from interior displacement data, which are provided by other modalities, such as ultrasound or magnetic resonance imaging. In this paper, we analyze the stability…
The Bayesian and Akaike information criteria aim at finding a good balance between under- and over-fitting. They are extensively used every day by practitioners. Yet we contend they suffer from at least two afflictions: their penalty…
This paper introduces diagnostic tests for the nature of lack of fit in ordinary differential equation models (ODEs) proposed for data. We present a hierarchy of three possible sources of lack of fit: unaccounted-for stochastic variation,…
Impedance is one of the vital parameters that provides useful information for many power electronics related applications. A lot of impedance measurement methods in power electronics have been reported. However, a comprehensive…
Existing methods for calculating substructure characteristic modes require treating interconnected metal structures as a single entity to ensure current continuity between different metal bodies. However, when these structures are treated…
Piezoelectric micro-electro-mechanical systems have significant market potential owing to their superior capabilities of transduction to those of standard capacitive and piezoresistive devices. However, piezoelectric films are often lossy,…