相关论文: 125-211 GHz Low Noise MMIC Amplifier Design for Ra…

Low cost, small footprint, highly efficient and mass producible on-chip wavelength-division-multiplexing (WDM) light sources are key components in future silicon electronic and photonic integrated circuits (EPICs) which can fulfill the…

We evaluate the performance of hybrid microwave resonators made by combining sputtered Nb thin films with Tungsten nanowires grown with a He-beam induced deposition technique. Depending on growth conditions the nanowires have a typical…

To this day, achieving broadband low-frequency sound absorption remains a challenge even with the possibilities promised by the advent of metamaterials and metasurfaces, especially when size and structural restrictions exist. Solving this…

We report on the noise of a lumped element Direct Current Superconducting Quantum Interference Device amplifier. We show that the noise temperature in the 4 GHz-8 GHz range over ranges of 10's of MHz is below 1 kelvin (three photons of…

High bandwidth, low voltage electro-optic modulators with high optical power handling capability are important for improving the performance of analog optical communications and RF photonic links. Here we designed and fabricated a thin-film…

In this paper, we consider the downlink of a massive multiple-input-multiple-output (MIMO) single user transmission system operating in the millimeter wave outdoor narrowband channel environment. We propose a novel receive spatial…

CMOS detectors offer many advantages over CCDs for optical and UV astronomical applications, especially in space where high radiation tolerance is required. However, astronomical instruments are most often designed for low light-level…

We present a SNAIL-based parametric amplifier that integrates a lumped-element impedance matching network for increased bandwidth and an on-chip pump-port filter for efficient pump delivery. The amplifier is fabricated using a single-layer…

The high energy beam transport (HEBT) line for the ISAC radioactive beam facility at TRIUMF requires an 11.8 MHz buncher. The main requirements of the buncher are to operate in cw mode with a velocity acceptance of 2.2% and an effective…

In this paper, we present an on-chip antenna at 290 GHz that achieves a maximum efficiency of 42\% on a low-resistivity silicon substrate for sub-terahertz integrated transceivers. The proposed antenna is based on a dual-slot structure to…

Electronic frequency mixers are fundamental building blocks of electronic systems. Harmonic frequency mixing in particular enables broadband electromagnetic signal analysis across octaves of spectrum using a single local oscillator.…

III-V heterostructure based high electron mobility transistors (HEMTs) offer superior performance as compared to CMOS silicon transistors owing to the high mobility in the 2D electron gas (2DEG) channel at the heterostructure interface.…

Josephson parametric amplifiers have emerged as a promising platform for quantum information processing and squeezed quantum states generation. Travelling wave and impedance-matched parametric amplifiers provide broad bandwidth for…

Previously, we had proposed an optically-pumped five-level Gain EIT (GEIT) system, which has a transparency dip superimposed on a gain profile and exhibits a negative dispersion suitable for the white-light-cavity signal-recycling (WLC-SR)…

We present the design and characterisation of a low-noise, resonant input transimpedance amplified photodetector. The device operates at a resonance frequency of $90 \,\textrm{MHz}$ and exhibits an input referred current noise of…

We show that the sensitivity of antenna-coupled field-effect transistors (FETs) to terahertz (THz) radiation improves continuously with decreasing temperature. The noise-equivalent power (NEP) of 540 GHz patch-antenna-coupled FETs decreases…

To improve both scalability and noise-filtering capability of a Transition-Edge Sensor (TES), a new concept of a thin-film detector is suggested, which is based on embedding a microbridge TES into a high-Q planar GHz range resonator weakly…

We employ a cryogenic High Electron Mobility Transistor (HEMT) amplifier to increase the bandwidth of a charge detection setup with a quantum point contact (QPC) charge sensor. The HEMT is operating at 1K and the circuit has a bandwidth of…

Millimeter wave (mmWave) MIMO will likely use hybrid analog and digital precoding, which uses a small number of RF chains to avoid energy consumption associated with mixed signal components like analog-to-digital components not to mention…

Direct-current superconducting quantum interference devices (dc-SQUIDs) are one of the most sensitive magnetic detectors. These sensors are extensively used in the readout of superconducting transition edge sensors (TESs), which are used…