相关论文: Thermoelectric Properties of BiSbTe Alloy Nanofilm…
The principles of the thermoelectric phenomenon, including Seebeck effect, Peltier effect, and Thomson effect are discussed. The dependence of the thermoelectric devices on the figure of merit, Seebeck coefficient, electrical conductivity,…
Thermoelectric films and periodic structures have particularly intriguing electrical and thermal transport features due to their low dimensionality. As a result, they have piqued the attention of researchers from across the spectrum of…
Thermoelectric materials, enabling the directing conversion between heat and electricity, are one of the promising candidates for overcoming environmental pollution and the upcoming energy shortage caused by the over-consumption of fossil…
At the ultra-thin limit below 20 nm, a film's electrical conductivity, thermal conductivity, or thermoelectricity depends heavily on its thickness. In most studies, each sample is fabricated one at a time, potentially leading to…
Thermoelectricity in telluride materials is often improved by replacing telluride with selenium in its crystal. Most work, however, focuses on bulk crystal and leaves the 2D thin films intact. In this paper, we optimize the fabrication of…
Hot wall technique was used to grow block single crystal films of Bi_2Te_3 and solid solutions of Bi_(0.5)Sb_(1.5)Te_3 on mica (muscovite) substrates. X-ray diffraction studies demonstrated that the crystalline c-axis in the films was…
Heat dissipation is one of the most serious problems in modern integrated electronics with the continuously decreasing devices size. Large portion of the consumed power is inevitably dissipated in the form of waste heat which not only…
The growing market for sensors, internet of things, and wearable devices is fueling the development of low-cost energy-harvesting materials and systems. Film based thermoelectric (TE) devices offer the ability to address the energy…
Thermoelectric materials intrigue much interest due to their wide range of application such as power generators and refrigerators. The efficiency of thermoelectric materials is quantified by the figure of merit, and a figure greater than…
Nanostructured materials and nanocomposites have shown great promise for improving the efficiency of thermoelectric materials. Herein, Fe nanoparticles were imbedded into a CrN matrix by combining two physical vapor deposition approaches,…
We report here metal to insulator transition, colossal Seebeck coefficient and ultralow thermal conductivity (0.0057th of its bulk value, significantly smaller than many well-known thermoelectric materials and silicon, showing potential…
Critical thermoelectric parameters including Seebeck coefficient, electrical conductivity, thermal conductivity and figure of merit ZT of one-dimensional coaxial Bi2Te3/Sb2Te3 nanocomposite were modeled by following the single carrier…
In recent years, nanoporous thin films have been widely studied for thermoelectric applications. High thermoelectric performance is reported for nanoporous Si films, which is attributed to the dramatically reduced lattice thermal…
The thermoelectric properties of two typical SiGe nanotubes are investigated using a combination of density functional theory, Boltzmann transport theory, and molecular dynamics simulations. Unlike carbon nanotubes, these SiGe nanotubes…
Large-volume deployment of Si-based Seebeck generators can be foreseen only if polycrystalline rather than single crystalline materials can be actually used. The aim of this study was therefore to verify whether polycrystalline Si films…
At the ultra-thin film limit, quantum confinement strongly improves thermoelectric figure of merit in materials such as Sb$_2$Te$_3$ and Bi$_2$Te$_3$. These high quality films have only been realized using well controlled techniques such as…
Nanostructured composites and nanowire arrays of traditional thermoelectrics like Bi, Bi(1-x)Sb(x) and Bi(2)Te(3) have metallic Rashba surface spin-orbit bands featuring high mobilities rivaling that of the bulk for which topological…
The Seebeck effect describes the generation of an electric potential in a conducting solid exposed to a temperature gradient. Besides fundamental relevance in solid state physics, it serves as a key quantity to determine the performance of…
Thermoelectric (TE) materials seamlessly convert thermal into electrical energy and vice versa, making them promising for applications such as power generation or cooling. Although historically the TE effect was first discovered in metals,…
Harvesting low-grade heat to electricity is attractive for powering wearable electronic devices. Here, we demonstrate nW-scale thermoelectric power generation in devices from thin film assemblies of microwave-synthesized p-Sb2Te3 nanoplates…