相关论文: A Novel Option for Waste Tire Rubber Reutilization…
The emergence of high transition temperature (Tc) superconductivity in strongly correlated materials remains a major unsolved problem in physics. High-Tc materials, such as cuprates, are generally complex and not easily tunable, making…
Two-dimensional transition metal dichalcogenides (TMDs) exhibit remarkable thermal anisotropy due to their strong intralayer covalent bonding and weak interlayer van der Waals (vdW) interactions. However, accurately modeling their thermal…
Regenerative braking energy is the energy produced by a train during deceleration. When a train decelerates, the motors act as generators and produce electricity. This energy can be fed back to the third rail and consumed by other trains…
Laminar drag reduction is a critical technology for enhancing the endurance and station-keeping capabilities of airship platforms. However, existing transport-based transition models fail to account for the premature transition induced by…
We propose a thermodynamic refrigeration cycle which uses Indefinite Causal Orders to achieve non-classical cooling. The cycle cools a cold reservoir while consuming purity in a control qubit. We first show that the application to an input…
The authors use two insulator layers in thermotunnel refrigerator to modify the shape of the tunneling barrier so that electrons with high kinetic energy pass it with increased probability. Theoretical analysis show that the overall…
The waste heat potential from industrial processes is huge and if it can be utilized it may contribute significantly to the mitigation of climate change. A packed bed thermal energy storage system is a low-cost storage technology that can…
As variable renewable energy sources comprise a growing share of total electricity generation, energy storage technologies are becoming increasingly critical for balancing energy generation and demand. In this study, we modeled an existing…
Thermoelectric generators (TEGs) based on commercially used thermal super-insulating materials can facilitate sustainable and large-scale ambient waste heat recovery while bequeathing an added economic and environmental value to thermal…
Although individual carbon nanotubes (CNTs) are superior as constituents to polymer chains, the mechanical and thermal properties of CNT fibers (CNTFs) remain inferior to commercial synthetic fibers due to the lack of synthesis methods to…
The global emphasis on sustainable technologies has become a paramount concern for nations worldwide. Specifically, numerous sustainable methods are being explored as promising alternatives to the well-established vapor-compression…
Tungsten (W) is a material of choice for the divertor material due to its high melting temperature, thermal conductivity, and sputtering threshold. However, W has a very high brittle-to-ductile transition temperature and at fusion reactor…
We report a dynamical-mechanical study of stress relaxation at small deformation in a natural (polyisoprene) rubber well above its glass transition temperature Tg. We find that an almost complete relaxation of stress takes place over very…
Solid-state cooling based on i-caloric effects is considered the most promising alternative to replace the conventional vapor-compression refrigeration systems. It is possible to define an i-caloric effect as a thermal response registered…
We predict the existence of a thermal bistability in many-body systems out of thermal equilibrium which exchange heat by thermal radiation using insulator-metal transition (IMT) materials. We propose a writing-reading procedure and…
The effects of thermal fluctuations on the morphology of two-dimensional materials are hard to harness. We propose that a geometrically constrained graphene nanoribbon (GNR) can exhibit thermally activated snap-through transitions with a…
Recently, thermal switching has been extensively studied because it is a key component for thermal management in electronic devices. Here, we show a huge magneto-thermal-switching ratio (MTSR) in pure Nb at temperatures lower than its…
A flat mounting unit with electronically variable thermal resistance [1] has been presented in the last year [2]. The design was based on a Peltier cell and the appropriate control electronics and software. The device is devoted especially…
The thermodynamic dislocation theory presented in preceding papers is used here to describe shear-banding instabilities. Central ingredients of the theory are a thermodynamically defined effective configurational temperature, and a formula…
The ever-increasing need for power consumption in electronic devices, coupled with the requirement for thinner size, calls for the development of efficient heat spreading components. Vapor chambers (VCs), because of their ability to…