相关论文: A non-intrusive reduced-order modeling method usin…

The two-layer quasi-geostrophic equations (2QGE) serve as a simplified model for simulating wind-driven, stratified ocean flows. However, their numerical simulation remains computationally expensive due to the need for high-resolution…

Steering a system towards a desired target in a very short amount of time is challenging from a computational standpoint. Indeed, the intrinsically iterative nature of optimal control problems requires multiple simulations of the physical…

This paper presents a novel adaptive-sparse polynomial dimensional decomposition (PDD) method for stochastic design optimization of complex systems. The method entails an adaptive-sparse PDD approximation of a high-dimensional stochastic…

High-performance computing enables simulation of high-dimensional physical systems, but downstream analyses such as inverse problems and control remain computationally expensive, motivating model order reduction (MOR) to construct efficient…

The definition of partial differential equation (PDE) models usually involves a set of parameters whose values may vary over a wide range. The solution of even a single set of parameter values may be quite expensive. In many cases, e.g.,…

Orthogonal polynomial approximations form the foundation to a set of well-established methods for uncertainty quantification known as polynomial chaos. These approximations deliver models for emulating physical systems in a variety of…

In this paper, we investigate tensor based nonintrusive reduced-order models (ROMs) for parametric cross-diffusion equations. The full-order model (FOM) consists of ordinary differential equations (ODEs) in matrix or tensor form resulting…

This paper discusses a methodology for determining a functional representation of a random process from a collection of scattered pointwise samples. The present work specifically focuses onto random quantities lying in a high dimensional…

This article considers the $\mathcal{H}_\infty$ static output-feedback control for linear time-invariant uncertain systems with polynomial dependence on probabilistic time-invariant parametric uncertainties. By applying polynomial chaos…

Electrical impedance tomography (EIT) is an imaging modality in which the conductivity distribution inside a target is reconstructed based on voltage measurements from the surface of the target. Reconstructing the conductivity distribution…

Traditional reduced order modeling techniques such as the reduced basis (RB) method (relying, e.g., on proper orthogonal decomposition (POD)) suffer from severe limitations when dealing with nonlinear time-dependent parametrized PDEs,…

A common strategy for the dimensionality reduction of nonlinear partial differential equations relies on the use of the proper orthogonal decomposition (POD) to identify a reduced subspace and the Galerkin projection for evolving dynamics…

Reduced-order modeling (ROM) commonly refers to the construction, based on a few solutions (referred to as snapshots) of an expensive discretized partial differential equation (PDE), and the subsequent application of low-dimensional…

In our previous work, a reduced order model (ROM) for a stochastic system was made, where noisy data was projected onto principal component analysis (PCA)-derived basis vectors to obtain an accurate reconstruction of the noise-free data.…

Extended Dynamic Mode Decomposition (EDMD) is a data-driven tool for forecasting and model reduction of dynamics, which has been extensively taken up in the physical sciences. While the method is conceptually simple, in deterministic chaos…

In this paper, we propose a computationally efficient iterative algorithm for proper orthogonal decomposition (POD) using random sampling based techniques. In this algorithm, additional rows and columns are sampled and a merging technique…

In this paper, we propose a computationally efficient iterative algorithm for proper orthogonal decomposition (POD) using random sampling based techniques. In this algorithm, additional rows and columns are sampled and a merging technique…

Reduced-order models are essential tools to deal with parametric problems in the context of optimization, uncertainty quantification, or control and inverse problems. The set of parametric solutions lies in a low-dimensional manifold (with…

In feedback flow control, one of the challenges is to develop mathematical models that describe the fluid physics relevant to the task at hand, while neglecting irrelevant details of the flow in order to remain computationally tractable. A…

We present an algorithm for computing sparse, least squares-based polynomial chaos expansions, incorporating both adaptive polynomial bases and sequential experimental designs. The algorithm is employed to approximate stochastic…