相关论文: Viable route towards large-area two dimensional Mo…
State-of-the-art fabrication and characterization techniques have been employed to measure the thermal conductivity of suspended, single-crystalline MoS2 and MoS2/hBN heterostructures. Two-laser Raman scattering thermometry was used…
We fabricate paper-supported semiconducting devices by rubbing a layered molybdenum disulfide (MoS2) crystal onto a piece of paper, similarly to the action of drawing/writing with a pencil on paper. We show that the abrasion between the…
Developing techniques for high-quality synthesis of mono and few-layered 2D materials with lowered complexity and cost continues to remain an important goal, both for accelerating fundamental research and for applications development. We…
2D semiconductors offer a promising pathway to replace silicon in next-generation electronics. Among their many advantages, 2D materials possess atomically-sharp surfaces and enable scaling the channel thickness down to the monolayer limit.…
Recent success in the growth of monolayer MoS$_2$ via chemical vapor deposition (CVD) has opened up prospects for the implementation of these materials into thin film electronic and optoelectronic devices. Here, we investigate the…
The charge-carrier transport properties of ultrathin metallic films are analysed with ab-initio methods using the density functional theory (DFT) on free-standing single crystalline slabs in the thickness range between 1 and 8 monolayers…
Micromechanically exfoliated mono- and multilayers of molybdenum disulfide (MoS2) are investigated by spectroscopic imaging ellipsometry. In combination with knife edge illumination, MoS2 flakes can be detected and classified on arbitrary…
We report on the superconducting properties of molybdenum nitride thin films grown by reactive DC sputtering at room temperature with a N2:Ar mixture. Thin films grown using 5 % N2 concentration display Tc = 8 K, which is gradually reduced…
Strain induced through fabrication, both by patterning and capping, can be used to change the properties of two-dimensional (2D) materials or other thin films. Here, we explore how capping layers impart strain to monolayer MoS$_{2}$ using…
In this work, amorphous thin films in Mg-Si-O-N system were prepared in order to investigate the dependence of optical and mechanical properties on Mg composition. Reactive RF magnetron co-sputtering from magnesium and silicon targets were…
Atomically thin two-dimensional (2D) semiconductors such as molybdenum disulphide (MoS2) hold great promise in electrical, optical, and mechanical devices and display novel physical phenomena such as coupled spin-valley physics and the…
Electrical and optical characterization of two-dimensional/three-dimensional (2D/3D) p-molybdenum disulfide/n-gallium nitride (p-MoS2/n-GaN) heterojunction diodes are reported. Devices were fabricated on high-quality, large-area p-MoS2…
We have developed an incandescent Mo source to fabricate large-area single-crystalline MoSe2 thin films. The as-grown MoSe2 thin films were characterized using transmission electron microscopy, energy dispersive X-ray spectroscopy, atomic…
Transition metal dichalcogenides like MoS$_2$, MoSe$_2$, WS$_2$, and WSe$_2$ have attracted enormous interest during recent years. They are van-der-Waals crystals with highly anisotropic properties, which allows exfoliation of individual…
Free-standing thin films of magnetic ion intercalated transition metal dichalcogenides are produced using ultramicrotoming techniques. Films of thicknesses ranging from 30nm to 250nm were achieved and characterized using transmission…
An experimental investigation was conducted to explore spectroscopic and structural characterization of semiconducting yttrium oxide thin film deposited at 623 K (+/- 5K) utilizing reactive pulsed direct current magnetron sputtering. Based…
In semiconductor physics, many essential optoelectronic material parameters can be experimentally revealed via optical spectroscopy in sufficiently large magnetic fields. For monolayer transition-metal dichalcogenide semiconductors, this…
Transition metal dichalcogenide MoS2 is a two-dimensional material, attracting much attention for next-generation applications thanks to rich functionalities stemmed from the crystal structure. Many experimental and theoretical works have…
The realization of ordered strain fields in two-dimensional crystals is an intriguing perspective in many respects, including the instauration of novel transport regimes and the achievement of enhanced device performances. In this work, we…
High throughput characterization and processing techniques are becoming increasingly necessary to navigate multivariable, data-driven design challenges for sensors and electronic devices. For two-dimensional materials, device performance is…