相关论文: Inertial Rise in Short Capillaries

Liquid in grooved capillaries, made by e.g. inserting a plate in a cylindrical tube, exhibits unusual spreading and flow properties. One example is capillary rise, where a long, upward tongue on top of the usual meniscus has been observed…

We consider theoretically liquid rise against gravity in capillaries with height-dependent cross-section. For a conical capillary made from a hydrophobic surface and dipped in a liquid reservoir, the equilibrium liquid height depends on the…

We study the capacity of active matter to rise in thin tubes against gravity and other related phenomena, like, wetting of vertical plates and spontaneous imbibition, where a wetting liquid is drawn into a porous medium. This capillary…

Capillary rise occurs when a thin tube contacts a liquid, which rises against gravity due to the capillary force. This phenomenon is present in a wide range of everyday and industrial settings and provides the means to measure the physical…

We study the dynamics of a fluid rising in a capillary tube with corners. In the cornered tube, unlike the circular tube, fluid rises with two parts, the bulk part where the entire cross-section is occupied by the fluid, and the finger part…

Capillary invasion of a liquid into an empty tube, which is called capillary rise when the tube axis is in the vertical direction, is one of the fundamental phenomena representing capillary effects. Usually, the tube is actually filled with…

The capillary flow of a ferrofluid in a single cylindrical capillary tube and through a sandy porous medium under the action of a non-uniform magnetic field is studied experimentally. The dynamics of the capillary rise and the static case…

A wetting liquid is driven through a thin gap due to surface tension and when the gap boundaries are elastic, the liquid deforms the gap as it rises. But when the fluid boundaries are also permeable (or poroelastic), the liquid can permeate…

The first large length-scale capillary rise experiments were conducted by R. Siegel using a drop tower at NASA LeRC shortly after the 1957 launch of Sputnik I. Siegel was curious if the wetting fluid would expel from the end of short…

This work proposes an ODE model for a capillary rise in pipes with variable cross section and compares it to the lubrication theory model. Two key assumptions are made: (1) radius of the pipe varies with axial coordinate, and (2) pipe's…

The capillary-induced structural instability of an elastic circular tube partially filled by a liquid is studied by combining theoretical analysis and molecular dynamics simulations. The analysis shows that, associated with the instability,…

This work revisits capillary filling dynamics in the regime of nanometric to subnanometric channels. Using molecular dynamics simulations of water in carbon nanotubes, we show that for tube radii below one nanometer, both the filling…

When a capillary is inserted into a liquid, the liquid will rapidly flow into it. This phenomenon, well studied and understood on the macroscale, is investigated by Molecular Dynamics simulations for coarse-grained models of nanotubes. Both…

In this fluid dynamics video, we report on experiments of large aspect ratio capillary surfaces supported by a helical wire. These open channels are potentially useful for fluid management at low Bond numbers. The experiments were performed…

When a square tube is brought in contact with bulk liquid, the liquid wets the corners of the tube, and creates finger-like wetted region. The wetting of the liquid then takes place with the growth of two parts, the bulk part where the…

We discuss the creeping motion of plugs of negligible viscosity in rough capillary tubes filled with carrier fluids. This extends Bretherton's research work on the infinite-length bubble motion in a cylindrical or smooth tube for small…

We study the imbibition of a wetting liquid between flexible sheets that are fixed on both ends. Assuming a narrow gap between the sheets, we solve the lubrication equation coupled with slender body deformation. When the sheets are…

Capillary forces acting at the surface of a liquid drop can be strong enough to deform small objects and recent studies have provided several examples of elastic instabilities induced by surface tension. We present such an example where a…

This work investigates the capillary rise dynamics of highly wetting liquids in a divergent U-tube in the microgravity conditions provided by 78th European Space Agency (ESA) parabolic flight. This configuration produces a capillary-driven…

We report and rationalize the observation of a crossover from the classical Lucas-Washburn dynamics to a long-lived anomalously slow regime for capillary rise in simple glass tubes. We propose an analytical model considering the role of…