相关论文: Recent RHIC in-situ coating technology development…
This work presents a novel cosmic-ray scattering experiment employing a Resistive Plate Chambers (RPC) muon tomography system. By introducing the scattering angle between incident and outgoing cosmic-ray tracks as a key observable, this…
The nozzle of an aircraft is a major source of radar scattering from the rear aspect of the aircraft, which undergoes higher operational temperatures. In order to reduce the radar scattering of these nozzles, high temperature radar…
A geometric model based on a spherical Fermi - surface and using the equivalent skin-layer model allows to calculate the surface resistance, which is relevant for the RF power losses in the cavity walls. An exact solution for this…
Ca- and Zn-subsituted Y1-xCaxBa2(Cu1-yZny)O7-delta (x = 0, 0.05 and y = 0, 0.02, 0.04, 0.05) thin films were grown on SrTiO3 (100) substrates using the pulsed laser deposition (PLD) technique. Effects of various growth parameters on the…
Micron-thick boron films have been deposited by Pulsed Laser Deposition in vacuum on several substrates at room temperature. The use of high energy pulses (>700 mJ) results in the deposition of smooth coatings with low oxygen uptake even at…
Hardware assurance of electronics is a challenging task and is of great interest to the government and the electronics industry. Physical inspection-based methods such as reverse engineering (RE) and Trojan scanning (TS) play an important…
We present a polarization-dependent infrared reflectivity study of the spin-ladder compound Sr$_{2.5}$Ca$_{11.5}$Cu$_{24}$O$_{41}$ under pressure. The optical response is strongly anisotropic, with the highest reflectivity along the…
A simple and low cost apparatus has been designed and built to measure the electrical resistivity, ($\rho$), of metal and semiconductors in 300-620 K temperature range. The present design is suitable to do measurement on rectangular bar…
Severe plastic deformation using high-pressure torsion of ternary Cu-based materials (CuFeCo and CuFeNi) was used to fabricate bulk samples with a nanocrystalline microstructure. The goal was to produce materials featuring the granular…
The structural, electronic, and magnetic properties of ultrathin Cu-coated Co nanowires have been studied by using empirical genetic algorithm simulations and a tight-binding $spd$ model Hamiltonian in the unrestricted Hartree-Hock…
Signal to noise ratios (SNR) in magnetic resonance microscopy images are limited by acquisition times and the decreasing number of spins in smaller voxels. Significant SNR gains from cooling of the RF receiver are only realized when the…
We report that high transport critical current density exceeding 104 A/cm2 at 4.2 K and 10 T can be obtained with good reproducibility for Ag sheathed (Ba,K)Fe2As2 (Ba 122) tapes by modifying the ex-situ powder-in-tube (PIT) method. The…
Surface temperature measurements were performed with a Scanning Thermal Microscope mounted with a thermoresistive wire probe of micrometrSurface temperature measurements were performed with a Scanning Thermal Microscope mounted with a…
Hydrogenated amorphous silicon (a-Si:H) has remarkable radiation resistance properties and can be deposited on a lot of different substrates. A-Si:H based particle detectors have been built since mid 1980s as planar p-i-n or Schottky diode…
We report measurements of the zero-field resistivity in dilute 2D electron system in silicon at temperatures down to 35 mK. This extends the previously explored range of temperatures by almost an order of magnitude. On the metallic side,…
We present results of carbon coatings on metal substrates in cylindrical hollow cathode (CHC) direct current magnetron sputtering. This is a new technique of making amorphous carbon film in CHC magnetron sputtering from regenerative sooting…
Axion dark matter searches require superconducting radio-frequency (SRF) cavities on copper (Cu) substrates with quality factors Q > 10^5 in multi-tesla magnetic fields. Copper reduces thermal noise and allows complex geometries. Nb3Sn is a…
Ultrarelativistic heavy-ion collisions at the Relativistic Heavy Ion Collider (RHIC) are thought to have produced a state of matter called the quark-gluon plasma, characterized by a very small shear-viscosity to entropy-density ratio…
Conventional powder-in-tube (PIT) method has been the most effective technique for fabricating iron-based superconducting wires and tapes. Tremendous advances have been made during the last few years, especially for 122 family pnictide…
High quality micro- and nano-mechanical resonators are widely used in sensing, communications and timing, and have future applications in quantum technologies and fundamental studies of quantum physics. Crystalline thin-films are…