相关论文: Softening induced instability of a stretched cohes…

We investigate the formation of stripe patterns that appear on the surface of a dry granular system as the container is deformed very slowly. In an experimental study using nearly mono-disperse glass beads, we found that many faults develop…

We study a coupled dynamics of a network and a particle system. Particles of density $\rho$ diffuse freely along edges, each of which is rewired at a rate given by a decreasing function of particle flux. We find that the coupled dynamics…

Usually, the strain-induced softening behaviour observed in the differential modulus $K(T,\gamma)$ of hydrogels has been attributed to the breakage of internal structures of the network, such as the cross-links that bind together the…

The stability of convection rolls in a fluid heated from below is limited by secondary instabilities, including the skew-varicose and crossroll instabilities. We observe a stability boundary defined by the same instabilities in stripe…

A hydrostatically stressed soft elastic film circumvents the imposed constraint by undergoing a morphological instability, the wavelength of which is dictated by the minimization of the surface and the elastic strain energies of the film.…

We investigate the elasticity of unsupported epithelial monolayer and we discover that unlike a thin solid plate, which wrinkles if geometrically incompatible with the underlying substrate, the epithelium may do so even in absence of the…

Wrinkling is the phenomenon of out-of-plane deformation patterns in thin walled structures, as a result of a local compressive (internal) loads in combination with a large membrane stiffness and a small but non-zero bending stiffness.…

We construct a homogeneous, nonlinear elastic constitutive law, that models aspects of the mechanical behavior of inhomogeneous fibrin networks. Fibers in such networks buckle when in compression. We model this as a loss of stiffness in…

A growing or compressed thin elastic sheet adhered to a rigid substrate can exhibit a buckling instability, forming an inward hump. Our study shows that the strip morphology depends on the delicate balance between the compression energy and…

We review a few representative examples of granular experiments or models where phase separation, accompanied by domain coarsening, is a relevant phenomenon. We first elucidate the intrinsic non-equilibrium, or athermal, nature of granular…

Unlike most synthetic materials, biological materials often stiffen as they are deformed. This nonlinear elastic response, critical for the physiological function of some tissues, has been documented since at least the 19th century, but the…

Gels are used to design bilayered structures with high residual stresses. The swelling of a thin layer on a compliant substrate leads to compressive stresses. The post-buckling of this layer is investigated experimentally; the wavelengths…

A new class of patterns for multiplex networks is studied, which consists in a collection of different homogeneous states each referred to a distinct layer. The associated stability diagram exhibits a tricritical point, as a function of the…

The wrinkling of thin elastic objects provides a means of generating regular patterning at small scales in applications ranging from photovoltaics to microfluidic devices. Static wrinkle patterns are known to be governed by an energetic…

Matrix stiffness expressions are derived for the particle movements in an assembly of rigid granules having compliant contacts. The derivations include stiffness terms that arise from the particle shapes at their contacts. These geometric…

Repeated loading of a solid leads to microstructural damage that ultimately results in catastrophic material failure. While posing a major threat to the stability of virtually all materials, the microscopic origins of fatigue, especially…

A simple micromechanical model of polycrystalline materials is proposed, which enables us to swiftly produce grain-boundary-stress distributions induced by the uniform external loading (in the elastic strain regime). Such statistical…

Strain in granular materials in quasistatic conditions under varying stress originate in (I) contact deformation and (II) rearrangements of the contact network. Depending on sample history and applied load, either mechanism might dominate.…

In layered materials, a common mode of deformation involves buckling of the layers under tensile deformation in the direction perpendicular to the layers. The instability mechanism, which operates in elastic materials from geological to…

Instabilities in thin elastic sheets, such as wrinkles, are of broad interest both from a fundamental viewpoint and also because of their potential for engineering applications. Nematic liquid crystal elastomers offer a new form of control…