相关论文: A New System Noise Measurement Method Using a 2-bi…

We consider general multi-antenna fading channels with coarsely quantized outputs, where the channel is unknown to the transmitter and receiver. This analysis is of interest in the context of sensor network communication where low power and…

Two-channel modulo analog-to-digital converters (ADCs) enable high-dynamic-range signal sensing at the Nyquist rate per channel, but existing designs quantise both channel outputs independently, incurring redundant bitrate costs. This paper…

This article proposes a method for the measurement of Phase Noise (PN, or PM noise) and Amplitude Noise (AN, or AM noise) of Digital-to-Analog Converters (DAC) and Direct Digital Synthesizers (DDS) based on modulation-index amplification.…

We analyze the phase-noise measurement methods in which correlation and averaging is used to reject the background noise of the instrument. All the known methods make use of a mixer, used either as a saturated phase detector or as a linear…

We report on efforts to improve the speed of low-G far-infrared transition-edged-sensed bolometers. We use a fabrication process that does not require any dry etch steps to reduce heat capacity on the suspended device and measure a…

With the advancement in the field of the Internet of Things(IoT) and Internet of Bodies(IoB), video camera applications using Video Sensor Nodes(VSNs) have gained importance in the field of autonomous driving, health monitoring, robot…

This paper focuses on channel estimation for mmWave MIMO systems with 1-bit spatial sigma-delta analog-to-digital converters (ADCs). The channel estimation performance with 1-bit spatial sigma-delta ADCs depends on the quantization noise…

In future high-capacity wireless systems based on mmWave or massive multiple input multiple output (MIMO), the power consumption of receiver Analog to Digital Converters (ADC) is a concern. Although hybrid or analog systems with fewer ADCs…

We apply noise thermometry to characterize charge and thermoelectric transport in single InAs nanowires (NWs) at a bath temperature of 4.2 K. Shot noise measurements identify elastic diffusive transport in our NWs with negligible…

An ADC is used to convert analog signals into binary signals. Compared with many other types of ADCs, flash converters are incredibly quick. A typical Flash ADC consists of 2n resistors, 2n-1 op-amp comparators, and an encoder which…

8-Gsps 1-bit Analog-to-Digital Converters (ADCs) were newly developed toward the realization of the wideband observation. The development of the wideband ADCs is one of the most essential developments for the radio interferometer. To…

Photonic analog to digital conversion offers promise to overcome the signal-to-noise ratio (SNR) and sample rate trade-off in conventional analog to digital converters (ADCs), critical for modern digital communications and signal analysis.…

We present the characterization of the CCD system developed for the ADFOSC instrument on the 3.6m Devasthal Optical Telescope (DOT). We describe various experiments performed to tune the CCD controller parameters to obtain optimum…

An AC susceptometer operating in the range of 10 Hz to 100 kHz and at room temperature is designed, built, calibrated and used to characterize the magnetic behaviour of coated magnetic nanoparticles. Other weakly magnetic materials (in…

One-bit analog-to-digital converter (ADC), performing signal sampling as an extreme simple comparator, is an overwhelming technology for spectrum sensing due to its low-cost, low-power consumptions and high sampling rate. In this letter, we…

This paper presents a dynamic predictive sampling (DPS) based analog-to-digital converter (ADC) that provides a non-uniform sampling of input analog continuous-time signals. The processing unit generates a dynamic prediction of the input…

A wireless acoustic sensor network records audio signals with sampling time and sampling rate offsets between the audio streams, if the analog-digital converters (ADCs) of the network devices are not synchronized. Here, we introduce a new…

A study of the conductance noise in a two-dimensional electron system (2DES) in Si at low temperatures (T) reveals the onset of large, non-Gaussian noise after cooling from an equilibrium state at a high T with a fixed carrier density n_s.…

In this letter, we investigate the robust beamforming design for an integrated sensing and communication (ISAC) system featuring low-resolution digital-to-analog converters (DACs) and analog-to-digital converters (ADCs). Taking into account…

This paper investigates a hardware-efficient massive multiple-input multiple-output integrated sensing and communication (MIMO-ISAC) system with 1-bit analog-to-digital converters (ADCs)/digital-to-analog converters (DACs). The proposed…