Related papers: Analysis of low-threshold optically pumped III-nit…
We report the isotropic plasma atomic layer etching (ALE) of aluminum nitride using sequential exposures of SF$_6$ plasma and trimethylaluminum (Al(CH$_3$)$_3$, TMA). ALE was observed at temperatures greater than 200 $^\circ$C, with a…
In this research, semiconductor-metallic hybrid nano-disk laser based on InGaAsP multi quantum wells (MQWs) or InGaAs bulk material membranes were designed, fabricated and characterized. The quality factors of surface-plasmon-polariton…
Manipulating at will the propagation dynamics of high power laser pulses is a long-standing dream whose accomplishment would lead to the control of a plethora of fascinating physical phenomena emerging from laser-matter interaction. The…
We propose the 3rd harmonic lasing in a new FLASH undulator as a way to produce intense, narrow-band, and stable SASE radiation down to 1.3 nm with the present accelerator energy of 1.25 GeV. To provide optimal conditions for harmonic…
We report on the characterization by a position resolved laser system of small-pitch 3D diodes irradiated with neutrons up to an extremely high fluence of 3.5x10**16 neq cm**-2. We show that very high values of signal efficiency are…
Squeezed states can be employed for entanglement-based continuous-variable quantum key distribution, where the secure key rate is proportional to the bandwidth of the squeezing. We produced a non-classical continuous-wave laser field at the…
We present a simple and flexible technique for identifying the onset of coherent emission in lasers, from the mesoscale to the nanoscale, which makes use of photon counting and a small amplitude modulation added to the pump. The optimal…
We have operated a CW triply resonant OPO using a PPLN crystal pumped by a Nd:YAG laser at 1.06 micron and generating signal and idler modes in the 2-2.3 micron range. The OPO was operated stably in single mode operation over large periods…
We report measurements of the optical responses of a La2/3Sr1/3MnO3 (LSMO) sample at a wavelength of 533 nm in the 300-400 K range. The 200 nm thick film was grown by pulsed laser deposition on (100) SrTiO3 substrate and showed remarkably…
We present the results of spectroscopic measurements in the extreme ultraviolet (EUV) regime (7-17 nm) of molten tin microdroplets illuminated by a high-intensity 3-J, 60-ns Nd:YAG laser pulse. The strong 13.5 nm emission from this…
We demonstrate a sensitive optically-pumped magnetometer using rubidium vapor and 0.75 amg of nitrogen buffer gas in a sub-mm-width sensing channel excavated by femtosecond laser writing followed by chemical etching. The channel is buried…
Laser drilling becomes of increasing importance when hole diameter is in the range of 10 to 50 mum, for which conventional alternative approaches are becoming difficult and cost inefficient. Furthermore, it is viewed as the technique of…
The control of large-scale quantum information processors based on arrays of trapped ions requires a means to route and focus multiple laser beams to each of many trapping sites in parallel. Here, we combine arrays of fibres, 3D…
N-polar (In,Ga)N/GaN quantum wells prepared on freestanding GaN substrates by plasma-assisted molecular beam epitaxy at conventional growth temperatures of about 650 {\deg}C do not exhibit any detectable luminescence even at 10 K. In the…
Novel thin-disk laser pump layouts are proposed yielding an increased number of passes for a given pump module size and pump source quality. These novel layouts result from a general scheme which bases on merging two simpler pump optics…
The efficiency and operating range of a photonic crystal laser is improved by passivating the InGaAs quantum well (QW) gain medium and GaAs membrane using an (NH4)S treatment. The passivated laser shows a four-fold reduction in nonradiative…
Three-dimensional (3D) printing has allowed for production of geometrically complex 3D objects with extreme flexibility, which is currently undergoing rapid expansions in terms of materials, functionalities, as well as areas of application.…
We investigate the dependence of the low-temperature photoluminescence linewidths from InP-lattice-matched InGaAs/InAlAs quantum wells on the low-angle misorientation from the (100) surface of the host InP substrate. Quantum wells were…
To investigate the physics of picosecond gain-switching dynamics in single-mode lasers under femtosecond optical pumping at room temperature, we designed and fabricated first-order surface-grating GaAs distributed-feedback (DFB) lasers with…
Nanophotonic circuits using group III-nitrides on silicon are still lacking one key component: efficient electrical injection. In this paper we demonstrate an electrical injection scheme using a metal microbridge contact in thin III-nitride…