相关论文: Low flicker-noise dc amplifier for 50 Ohm sources
Amplification is usually necessary when measuring the frequency instability of microwave signals. In this work, we develop a flicker noise free frequency measurement system based on a common or shared amplifier. First, we show that…
Understanding the amplifier phase noise is a critical issue in numerous fields of engineering and physics, like oscillators, frequency synthesis, telecommunications, radars, spectroscopy, in the emerging domain of microwave photonics, and…
A tabletop low-noise differential amplifer with a bandwidth of 100 kHz is presented. Low voltage drifts of the order of 100 nV/day are reached by thermally stabilizing relevant amplifer components. The input leakage current is below 100 fA.…
A field-effect transistor (FET) amplifier for small voltage signals is presented. Its design is elementary and the construction can be afforded by anyone. Despite its simplicity, with a voltage noise less than 1 nV/sqrt(Hz), it outperforms…
A low-noise amplifier (LNA) amplifies a very low-power signal without significantly degrading its signal-to-noise ratio. This paper provides the design of a linear low noise amplifier with the transistor BFP 640 using bilateral approach…
A transimpedance amplifier has been designed for scanning tunneling microscopy (STM). The amplifier features low noise (limited by the Johnson noise of the 1 G{\Omega} feedback resistor at low input current and low frequencies), sufficient…
A low noise constant current source used for measuring the $1/f$ noise in disordered systems in ohmic as well as non-ohmic regime is described. The source can supply low noise constant current starting from as low as 1 $\mu$A to a few tens…
The resolution of low-frequency resistance noise measurements can be increased by amplitude modulation, shifting the spectrum of the resistance fluctuations away from the 1/f noise contributed by measurement instruments. However, commercial…
We report on the design and characterization of a high-power amplifier with an output power of 36.5 dBm for a frequency range of 50 MHz to 1000 MHz with a total gain of 40 dB. The amplifier is optimized for driving acousto-optic and…
The close-in AM noise is often neglected, under the assumption that it is a minor problem as compared to phase noise. With the progress of technology and of experimental science, this assumption is no longer true. Yet, information in the…
The present article primarily focuses on the design of an ultra-low-noise amplifier specifically tailored for quantum applications. The circuit design places a significant emphasis on improving the noise figure, as quantum-associated…
The microwave signal at the output of a photodiode that detects a modulated optical beam contains the phase noise phi(t) and the amplitude noise alpha(t) of the detector. Beside the white noise, which is well understood, the spectral…
This paper proposes a low-power and low-noise instrumentation amplifier (IA) tailored for bioimpedance sensing applications. The design originates from a gain-boosted flipped voltage follower (FVF) transconductance (TC) stage and integrates…
The measurement of the close-to-the-carrier noise of rf and microwave devices is a relevant issue in time and frequency metrology and in some fields of electronics, physics and optics. While phase noise is the main concern, amplitude noise…
A new approach was developed for the design of front-end circuits for semiconductor radiation detectors. The readout scheme consists of a first stage made of only a few components located close to the detector, and of a remote second stage…
Low-frequency resonances with low stability margins affect video bandwidth characteristics of power amplifiers. In this work, a non-connectorized measurement technique is presented to obtain the low-frequency critical poles at internal…
We introduce a novel measurement method for the phase noise measurement of optical amplifiers, topologically similar to the Heterodyne Mach-Zehnder Interferometer but governed by different principles, and we report on the measurement of a…
The design and performance of a sensitive and reliable cross-correlation spectrum analyzer for studying low frequency transport noise is described in detail. The design makes use of common PC-based data acquisition hardware and…
We demonstrate a low noise, high-gain, resonant optical amplifier that combines injection locking with feed-forward cancellation of residual phase noise. The wavelength-agnostic architecture uses a commercial semiconductor diode laser as a…
Far-infrared detectors for future cooled space telescopes require ultra-sensitive detectors with optical noise equivalent powers of order 0.2 aW/\sqrt Hz. This performance has already been demonstrated in arrays of transition edge sensors.…