相关论文: Reconstruction of Initial Beam Conditions at the E…

The Dual-Axis Radiographic Hydrotest (DARHT) facility uses bremsstrahlung radiation source spots produced by the focused electron beams from two linear induction accelerators (LIAs) to radiograph large hydrodynamic experiments driven by…

Diagnostic X (D-X) transport system would extract the beam from the downstream transport line of the second- axis of the Dual Axis Radiographic Hydrodynamic Test facility (DARHT-II) and transport this beam to the D-X firing point via four…

Using a particle-in-cell (PIC) code, we investigated the possibilities for emittance growth through the quadrupole magnets of the system used to transport the high-current electron beam from an induction accelerator to the bremsstrahlung…

When a beam propagates in an accelerator, it interacts with both the external fields and the self-generated electromagnetic fields. If the latter are strong enough, the interplay between them and a perturbation in the beam distribution…

To make full use of photocathode material and improve its quantum efficiency lifetime, it can be necessary to operate laser away from the cathode center in photoinjectors. In RF guns, the off-axis emitted beam will see a time-dependent RF…

The axis tilt of light beam in optical system would introduce the dispersion of orbital angular momentum (OAM) spectrum. To deal with it, a two-step method is proposed and demonstrated. First, the tilt angle of optical axis is identified…

Beam diagnostics and instrumentation are an essential part of any kind of accelerator. There is a large variety of parameters to be measured for observation of particle beams with the precision required to tune, operate, and improve the…

High-power hadron accelerators have strict limits on fractional beam loss. In principle, once a high-quality beam is set up in an acceptable state, beam loss should remain steady. However, in practice, there are many trips in operational…

In this paper we study the problem of inferring the initial conditions of a dynamical system under incomplete information. Studying several model systems, we infer the latent microstates that best reproduce an observed time series when the…

Precise alignment of the electron beam is critical for successful application of scanning transmission electron microscopes (STEM) to understanding materials at atomic level. Despite the success of aberration correctors, aberration…

A conventional method to determine beam parameters is using the profile measurements and converting them into the values of twiss parameters and beam emittance at a specified position. The beam information can be used to improve transverse…

Many advanced techniques have been developed, tested and implemented in the last decades in almost all circular accelerators across the world to measure the linear optics. However, the greater availability and accuracy of beam diagnostics…

We quantify the error in the results of mixed baryon--dark-matter hydrodynamic simulations, stemming from outdated approximations for the generation of initial conditions. The error at redshift 0 in contemporary large simulations, is of the…

In this paper, we study a multi-objective inverse initial problem with a Nash strategy constraint for forward stochastic reaction-diffusion equations with dynamic boundary conditions, where both the volume and surface equations are…

Odometer-aided visual-inertial SLAM systems typically have a good performance for navigation of wheeled platforms, while they usually suffer from degenerate cases before the first turning. In this paper, firstly we perform an observability…

We present proper motion (PM) measurements for Draco II, an ultra-faint dwarf satellite of the Milky Way. These PMs are measured using two epochs of Hubble Space Telescope Advanced Camera for Surveys (HST/ACS) imaging separated by a 7 year…

This paper describes the mechanical design of the downstream beam transport line for the second axis of the Dual Axis Radiographic Hydrodynamic Test (DARHT II) Facility. The DARHT-II project is a collaboration between LANL, LBNL and LLNL.…

The proof test and debugging of the multi-pulsed electron accelerator, Dragon-2,requires a thorough comprehension of the quality of the beams. This puts forward a rigid requirement on the measurement system that it should have the ability…

An autonomous robot with a limited vision range finds a path to the goal in an unknown environment in 2D avoiding polygonal obstacles. In the process of discovering the environmental map, the robot has to return to some positions marked…

A two-stage batch estimation algorithm for solving a class of nonlinear, static parameter estimation problems that appear in aerospace engineering applications is proposed. It is shown how these problems can be recast into a form suitable…