相关论文: Development and geometry of isotropic and directio…

We numerically investigate the athermal creep deformation of amorphous materials having a wide range of stability. The imposed shear stress serves as the control parameter, allowing us to examine the time-dependent transient response…

We investigate experimentally the drying of a small volume of perfectly wetting liquid on two crossed fibers. We characterize the drying dynamics for the three liquid morphologies that are encountered in this geometry: drop, column and a…

Granulate physics has made considerable progress during the past decades in the understanding of static and dynamic properties of large ensembles of interacting macroscopic particles, including the modeling of phenomena like jamming,…

The behavior of shear-oscillated amorphous materials is studied using a coarse-grained model. Samples are prepared at different degrees of annealing and then subject to athermal and quasistatic oscillatory deformations at various fixed…

Amorphous solids lack long-range order. Therefore identifying structural defects -- akin to dislocations in crystalline solids -- that carry plastic flow in these systems remains a daunting challenge. By comparing many different structural…

A thin circular elastic sheet floating on a drop-like liquid substrate is deformed due to incompatibility between the curved substrate and the planar sheet. We adopt a variational viewpoint by minimizing the non-convex membrane energy…

Instabilities at interface of two stream granular flows have been reported in recent experiment [1] that breaking waves can form at the interface between two streams of identical grains flowing on an inclined plane downstream of a splitter…

In this article, I study the shear thickening of suspensions of frictional dimers by the mean of numerical simulations. I report the evolution of the main parameters of shear thickening, such as the jamming volume fractions in the…

We develop a theory for drying-induced stresses in sessile, poroelastic drops undergoing evaporation on rigid surfaces. Using a lubrication-like approximation, the governing equations of three-dimensional nonlinear poroelasticity are…

Charged colloidal dispersions make up the basis of a broad range of industrial and commercial products, from paints to coatings and additives in cosmetics. During drying, an initially liquid dispersion of such particles is slowly…

Evolution of composition patterns in the annealed, single-crystal surface alloy film is considered in the presence of the spinodal decomposition, the compositional stress and the diffusion anisotropy. While the former two effects contribute…

Droplets confined in a microfluidic channel often exhibit intriguing shapes, primarily attributable to complex hydrodynamic interactions over small scales. We show that effect of varied substrate wettability conditions may further…

The relevant parameters at the microstructure scale that govern the macroscopic toughness of disordered brittle materials are investigated theoretically. We focus on planar crack propagation and describe the front evolution as the…

The adhesion of a stiff film onto a curved substrate often generates elastic stresses in the film that eventually give rise to its delamination. Here we predict that delamination of very thin films can be dramatically suppressed through…

In simulations and experiments, we study the drying of films containing mixtures of large and small colloidal particles in water. During drying, the mixture stratifies into a layer of the larger particles at the bottom with a layer of the…

Thin elastic sheets bend easily, leading to mechanical instabilities such as wrinkling. Here, we investigate wrinkles at edges of bi-strips, which consist of two thin sheets, one that swells and one that does not, joined side-by-side. It is…

This short review is devoted to the simple process of drying a multi-component droplet consisting of a complex fluid containing a salt. These processes provide a fascinating subject for study. The explanation of the rich variety of patterns…

During drying of colloidal suspensions, colloidal particles can form concentrated particle layers beneath the receding free surface. The drying rate can gradually decrease with the growth of the particle layers. We construct a model to…

The ordering of particles in the drying process of a colloidal suspension is crucial in determining the properties of the resulting film. For example, microscopic inhomogeneities can lead to the formation of cracks and defects that can…

Using the theory of elasticity of polymer gels we show that large-scale cross-link density patterns written into the structure of the network in the melt state, can be revealed upon swelling by monitoring the monomer density patterns. We…