相关论文: Drag Reduction by Microbubbles in Turbulent Flows:…
Drag reduction in stationary turbulent flows by bubbles is sensitive to the dynamics of bubble oscillations. Without this dynamical effect the bubbles only renormalize the fluid density and viscosity, an effect that by itself can only lead…
The flow of fluids in channels, pipes or ducts, as in any other wall-bounded flow (like water along the hulls of ships or air on airplanes) is hindered by a drag, which increases many-folds when the fluid flow turns from laminar to…
In the maritime industry, the injection of air bubbles into the turbulent boundary layer under the ship hull is seen as one of the most promising techniques to reduce the overall fuel consumption. However, the exact mechanism behind bubble…
We investigate the effect of microbubbles on Taylor-Couette flow by means of direct numerical simulations. We employ an Eulerian-Lagrangian approach with a gas-fluid coupling based on the point-force approximation. Added mass, drag, lift,…
In this study we experimentally investigate bubbly drag reduction in a highly turbulent flow of water with dispersed air at $5.0 \times 10^{5} \leq \text{Re} \leq 1.7 \times 10^{6}$ over a non-wetting surface containing micro-scale…
The phenomenon of drag reduction induced by injection of bubbles into a turbulent carrier fluid has been known for a long time; the governing control parameters and underlying physics is however not well understood. In this paper, we use…
The drag reduction induced by superhydrophobic surfaces is investigated in turbulent pipe flow. Wetted superhydrophobic surfaces are shown to trap gas bubbles in their asperities. This stops the liquid from coming in direct contact with the…
To further understand their nature, micro cavitation bubbles were systematically diffused around the exterior of a test body (tube) fully submerged in a water tank. The primary purpose was to assess the feasibility of applying micro…
In most settings, from international pipelines to home water supplies, the drag caused by turbulence raises pumping costs many times higher than if the flow were laminar. Drag reduction has therefore long been an aim of high priority. In…
A turbulent pipe flow experiment was conducted where the surface of the pipe was oscillated azimuthally over a wide range of frequencies, amplitudes and Reynolds number. The drag was reduced by as much as 30\%. Past work has suggested that…
A small amount of polymer additives can cause substantial reduction in the energy dissipation and friction loss of turbulent flow. The problem of polymer-induced drag reduction has attracted continuous attention over the seven decades since…
A theoretical expression for the drag on a spherical bubble is derived for the entire range from very viscous to inertial flow conditions. It is based on a solution for only that part of the velocity profile that determines the drag. It is…
The frictional forces of a viscous liquid flow are a major energy loss issue and severely limit microfluidics practical use. Reducing this drag by more than a few tens of percent remain illusive. Here, we show how cylindrical…
We hypothesize that combining extreme turbulence with a minute reduction in surface tension $\sigma$ (surface tension of the liquid) using surfactant provides a simple and scalable route for controlling micron scale bubble size in…
Injection of dilute polymer in a turbulent flow suppresses frictional drag. This challenging and technologically important problem remains primarily unresolved due to the complex nature of the flow. An important factor in the drag reduction…
The phenomenon of drag reduction by polymer additives had been studied in simulations on the basis of non-Newtonian fluid mechanical models that take into account the field of polymer extension (conformation tensor) and its interaction with…
An addition of polymers can significantly reduce drag in wall-bounded turbulent flows, such as pipes or channels. This phenomenon is accompanied by a noticeable modification of the mean velocity profile. Starting from the premise that…
Air lubrication regimes were studied using simultaneous drag force measurements and multi-plane imaging to characterize the regimes and identify the governing mechanisms of drag reduction. A bubbly, transitional, and air layer regime are…
Inspired by the lotus effect, many studies in the last decade have focused on micro- and nano-patterned surfaces. They revealed that patterns at the micro-scale combined with high contact angles can significantly reduce skin drag. However,…
What is the turbulent drag force experienced by an object moving in a rotating fluid? This open and fundamental question can be addressed by measuring the torque needed to drive an impeller at constant angular velocity $\omega$ in a water…