相关论文: Time Dispersion and Efficiency of Detection for Si…

We present a time-frequency method to detect gravitational wave signals in interferometric data. This robust method can detect signals from poorly modeled and unmodeled sources. We evaluate the method on simulated data containing noise and…

We report the result from a search for bursts of gravitational waves using data collected by the cryogenic resonant detectors EXPLORER and NAUTILUS during the year 2001, for a total measuring time of 90 days. With these data we repeated the…

The millihertz gravitational wave band is expected to be opened by space-borne detectors like TianQin. Various mechanisms can produce short outbursts of gravitational waves, whose actual waveform can be hard to model. In order to identify…

In order to reach the sensitivity required to detect gravitational waves, pulsar timing array experiments need to mitigate as much noise as possible in timing data. A dominant amount of noise is likely due to variations in the dispersion…

Non-Gaussian noise in gravitational-wave detectors, known as "glitches," can bias the inferred parameters of transient signals when they occur nearby in time and frequency. These biases are addressed with a variety of methods that remove or…

We present results of the search for coincident burst excitations over a 24 hours long data set collected by AURIGA, EXPLORER, NAUTILUS and Virgo detectors during September 2005. The search of candidate triggers was performed independently…

Crosscorrelation of the outputs of two Gravitational Wave (GW) detectors has recently been proposed [1] as a method for detecting statistical association between GWs and Gamma Ray Bursts (GRBs). Unfortunately, the method can be effectively…

We performed a search for short gravitational wave bursts using about 3 years of data of the resonant bar detectors Nautilus and Explorer. Two types of analysis were performed: a search for coincidences with a low background of accidentals…

Coincidences are searched with the cryogenic resonant gravitational wave detectors EXPLORER and NAUTILUS, during a period of about six months (2 June-14 December 1998) for a total measuring time of 94.5 days, with the purpose to study new…

The potential of compressed sensing for obtaining sparse time-frequency representations for gravitational wave data analysis is illustrated by comparison with existing methods, as regards i) shedding light on the fine structure of noise…

The article reviews the statistical theory of signal detection in application to analysis of deterministic gravitational-wave signals in the noise of a detector. Statistical foundations for the theory of signal detection and parameter…

We estimate the signal-to-noise ratio for two gravitational detectors interacting with a stochastic background of massive scalar waves. We find that the present experimental level of sensitivity could be already enough to detect a signal…

We present a method for assigning a statistical significance to detection candidates in targeted searches for continuous gravitational waves from known pulsars, without assuming the detector noise is Gaussian and stationary. We take…

A search for periodic gravitational-wave signals from isolated neutron stars in the NAUTILUS detector data is presented. We have analyzed half a year of data over the frequency band $<922.2; 923.2>$ Hz, the spindown range…

We show that gravitational-wave signals from compact binary mergers may be better distinguished from instrumental noise transients by using Bayesian models that look for signal coherence across a detector network. This can be achieved even…

We present a new idea that allows us to detect gravitational waves without being disturbed by any kind of displacement noise, based on the fact that gravitational waves and test-mass motions affect the propagations of light differently. We…

We have developed a full model to simulate spherical detectors where all main sources of noise are considered. We have built a computer code for determining the source direction and the wave polarization (solution of the inverse problem) in…

The recently published analysis of the coincidences between the EXPLORER and NAUTILUS gravitational wave detectors in the year 2001 (Astone et al. 2002) has drawn some criticism (Finn 2003). We do not hold with these objections, even if we…

Here I examine how to determine the sensitivity of the LIGO, VIRGO, and LAGOS gravitational wave detectors to sources of gravitational radiation by considering the process by which data are analyzed in a noisy detector. By constructing the…

We determine the transfer functions of two kinds of filters that can be used in the detection of continuous gravitational radiation. The first one optimizes the signal-to-noise ratio, and the second reproduces the wave with minimum error.…