相关论文: Electronic Structures and Bonding of Oxygen on Plu…

Density-functional calculations on the polar TiX(111) (X = C, N) surfaces show (i) for clean surfaces, strong Ti3d-derived surface resonances (SR's) at the Fermi level and X2p-derived SR's deep in the upper valence band and (ii) for adatoms…

The adsorption of MgO molecules on a Fe(001) surface was studied using density functional theory (DFT) and projector augmented wave methods. The energetically most favored configurations for different adsorption sites considered were…

We present a detailed study of the adsorption of CO on Cu, Rh, and Pt (111) surfaces in top and hollow sites. The study has been performed using the local density approximation, the gradient corrected functional PBE, and the hybrid…

The adsorption of rare gases on metal surfaces serve as the paradigm of weak adsorption where it is typically assumed that the adsorbate occupies maximally coordinated hollow sites. Density-functional theory calculations using the…

We present and discuss the results of ab initio DFT plane-wave supercell calculations of the atomic and molecular oxygen adsorption and diffusion on the LaMnO3 (001) surface which serves as a model material for a cathode of solid oxide fuel…

The spin-density functional theory (DFT) and DFT+$U$ with Hubbard $U$ term accounting for on-site Coulomb interactions were applied to investigate structure, stability, and electronic properties of different terminations of the…

The Work function (f)is fundamental for chemistry and electronics. Additionally, f can be used to examine the validity of the theoretical surfaces by comparing it with experimental f, even in the absence of long-range orders. In the…

We present a density functional study of the structural and electronic properties of small Cu_n (n=1,4) aggregates on defect-free MgO(100). The calculations employ a slab geometry with periodic boundary conditions, supercells with up to 76…

The dissociative adsorption of methane on variously oxidized Pd, Pt and Pd-Pt surfaces is investigated using density-functional theory, as a step towards understanding the combustion of methane on these materials. For Pd-Pt alloys, models…

To help provide insight into the remarkable catalytic behavior of the oxygen/silver system for heterogeneous oxidation reactions, purely sub-surface oxygen, and structures involving both on-surface and sub-surface oxygen, as well as…

The adsorption of pentacene on Cu(221), Cu(511) and Cu(911) is investigated using density functional theory (DFT) with the self-consistent inclusion of van der Waals (vdW) interactions. Cu(211) is a vicinal of Cu(111) while Cu(511) and…

Relaxed atomic geometries and chemisorption energies have been calculated for the dissociative adsorption of molecular hydrogen on vicinal Si(001) surfaces. We employ density-functional theory, together with a pseudopotential for Si, and…

First principles density functional calculations are used to study the early oxidation stages of the Mg(0001) surface for oxygen coverages 1/16 <= Theta <= 3 monolayers. It is found that at very low coverages O is incorporated below the…

The results of DFT GGA calculations on oxygen molecules adsorbed upon the (001) surface of uranium mononitride (UN) are presented and discussed. We demonstrate that O2 molecules oriented parallel to the substrate can dissociate either (i)…

Knowledge of the atomic geometry of a surface is a prerequisite for any detailed understanding of the surface's electronic structure and chemical properties. Previous studies have convincingly demonstrated that density functional theory…

First-principles calculations based on density functional theory (DFT) and the pseudopotential method have been used to study the stoichiometric and reduced SnO2 (110) surface. The ionic relaxations are found to be moderate for both the…

Theoretical calculations based on density functional theory have made significant contributions to our understanding of metal oxides, their surfaces, and the binding of molecules at these surfaces. In this paper we investigate the binding…

We present a Density Functional Theory (DFT) study of the structural and electronic properties of bare rutile VO$_{2}$(110) surfaces and its oxygen-rich terminations. We discuss the performance of various DFT functionals, including PBE,…

Using first-principles calculations, we systematically study the adsorption behavior of a single molecular H$_{2}$O on the Be(0001) surface. We find that the favored molecular adsorption site is the top site with an adsorption energy of…

By means of density functional theory we have undertaken a structural, electronic and magnetic survey of the adsorption of the Fe_xPt_y(x,y=<4) clusters on MgO (001) surface under the generalized gradient approximation. We have tested…