相关论文: Enhanced photothermal displacement spectroscopy fo…
We report the experimental observation of the photothermal effect. The measurements are performed by modulating the laser power absorbed by the mirrors of two high-finesse Fabry-Perot cavities. The results are very well described by a…
We demonstrate a robust and miniaturized fiber Fabry-Perot cavity-based sensor for photothermal spectroscopic signal retrieval. The proof-of-concept experiment involved the use of a near-infrared pump laser to detect methane molecules on an…
We have measured the photothermal effect in a single cross-polarized interferometer at audio frequencies (5 Hz - 4 kHz). In a Fabry-Perot interferometer, light in one polarization is chopped to periodically heat the interferometer mirrors,…
Increasing requirements in the sensitivity of interferometric measurements is a common feature of several research fields, from gravitational wave detection to quantum optics. This motivates refined studies of high reflectivity mirrors and…
We develop a steady-state analytical and numerical model of the optical response of power-recycled Fabry-Perot Michelson laser gravitational-wave detectors to thermal focusing in optical substrates. We assume that the thermal distortions…
Measuring temperature fields in semi-transparent media requires the knowledge of material thermo-optic properties. While the current techniques are well established for isothermal thin films, they remain unexplored for thick media where…
We show that under proper conditions thin films structures behave like thermal sources that are able to emit radiation in well defined directions over a broad spectral band for both polarization states of light. This effect results from the…
The achievable instrument sensitivity is a critical parameter for the continued development of THz applications. Techniques such as Cavity-Enhanced Techniques and Cavity Ring Down Spectroscopy have not yet been employed at THz frequency due…
We show that anomalous dispersion characteristic of fast-light can be used to enhance the sensitivity of optical interferometry under certain conditions. In particular, we show that a dual-chamber Fabry-Perot interferometer with a shared…
Displacement calibration of nanomechanical plate resonators presents a challenging task. Large nanomechanical resonator thickness reduces the amplitude of the resonator motion due to its increased spring constant and mass, and its unique…
In nanomechanical photothermal absorption spectroscopy and microscopy, the measured substance becomes a part of the detection system itself, inducing a nanomechanical resonance frequency shift upon thermal relaxation. Suspended,…
We demonstrate Purcell-like enhancement of Rayleigh scattering into a single optical mode of a Fabry-Perot resonator for several thermal atomic and molecular gases. The light is detuned by more than an octave, in this case by hundreds of…
The displacement field of an object surface can be measured by using speckle interferometry. This technique is based on the phenomenon of laser speckle and consists in correlating speckle interferograms taken after and before the…
The past five years have seen a rapid rise in the use of tunable filters in many diverse fields of astronomy, through Taurus Tunable Filter (TTF) instruments at the Anglo-Australian and William Herschel Telescopes. Over this time we have…
We propose and implement a quantum procedure for enhancing the sensitivity with which one can determine the phase shift experienced by a weak light beam possessing thermal statistics in passing through an interferometer. Our procedure…
We present a pressure sensor based on a Michelson interferometer, for use in photoacoustic tomography. Quadrature phase detection is employed allowing measurement at any point on the mirror surface without having to retune the…
Thermal effects are already important in currently operating interferometric gravitational wave detectors. Planned upgrades of these detectors involve increasing optical power to combat quantum shot noise. We consider the ramifications of…
Optical multilayer coatings of high-reflective mirrors significantly determine the properties of Fabry-Perot resonators. Thermal (Brownian) noise in these coatings produce excess phase noise which can seriously degrade the sensitivity of…
We have used a photothermal technique, in which chopped light heats the front surface of a small ( ~ 1 mm2) sample and the chopping frequency dependence of thermal radiation from the back surface is measured with a liquid nitrogen cooled…
We propose using THz frequency selective surfaces interrogated with THz subwavelength optical fibers as sensors for monitoring of the optical properties of thick films that are brought in contact with such surfaces. Changes in the test film…