相关论文: On Improvement of Control Chart using Repetitive S…
In this study, we considered the design and performance of control charts using neoteric ranked set sampling (NRSS) in monitoring normal distributed processes. NRSS is a recently proposed sampling design, based on the traditional ranked set…
Regression control charts are usually used to monitor variables of interest that are related to control variables. However, for fraction and/or proportion data, the use of standard regression control charts may not be adequate, since the…
Maintaining the quality of manufactured products at a desired level is known to increase customer satisfaction and profitability. Shewhart control chart is the most widely used in statistical process control (SPC) technique to monitor the…
The traditional variable control charts, such as the X-bar chart, are widely used to monitor variation in a process. They have been shown to perform well for monitoring processes under the general assumptions that the observations are…
In many industrial manufacturing processes, the quality of products depends on the relation between two main ingredients or characteristics. Often, this calls for monitoring the ratio of two normal random variables with statistical process…
In Statistical Process Control, control charts are often used to detect undesirable behavior of sequentially observed quality characteristics. Designing a control chart with desirably low False Alarm Rate (FAR) and detection delay ($ARL_1$)…
In this article an SPC case study is presented. It consists of monitoring a manufacturing process used for different products of similar kind. So far, each of these products is monitored individually. However, if there is e.g. a quality…
To maintain the desired quality of a product or service it is necessary to monitor the process that results in the product or service. This monitoring method is called Statistical Process Management, or Statistical Process Control. It is in…
Woodall and Montgomery [35] in a discussion paper, state that multivariate process control is one of the most rapidly developing sections of statistical process control. Nowadays, in industry, there are many situations in which the…
Control charts, as had been used traditionally for quality monitoring, were applied alternatively to monitor systems' reliability. In other words, they can be applied to detect changes in the failure behavior of systems. Such purpose…
Monitoring a process over time is so important in manufacturing processes to reduce the waste of money and time. Some charts as Shewhart, CUSUM, and EWMA are common to monitor a process with a single intended attribute which is used in…
Traditional Statistical Process Control (SPC) is essential for quality management but is limited by its reliance on often violated statistical assumptions, leading to unreliable monitoring in modern, complex manufacturing environments. This…
Sequential inspection is a technique employed to monitor product quality during the production process. For smaller batch sizes, the Acceptable Quality Limit(AQL) inspection theory is typically applied, whereas for larger batch sizes, the…
Over the years, the most popularly used control chart for statistical process control has been Shewhart's $\bar{X}-S$ or $\bar{X}-R$ chart along with its multivariate generalizations. But, such control charts suffer from the lack of…
In statistical process control, procedures are applied that require relatively strict conditions for their use. If such assumptions are violated, these methods become inefficient, leading to increased incidence of false signals. Therefore,…
In practice, there are processes where the in-control mean and standard deviation of a quality characteristic is not stable. In such cases, the coefficient of variation (CV) is a more appropriate measure for assessing process stability. In…
To use control charts in practice, the in-control state usually has to be estimated. This estimation has a detrimental effect on the performance of control charts, which is often measured for example by the false alarm probability or the…
The Statistical Process Control (SPC) and the Automated Process Control (APC) have a common goal: achieve optimal product quality by controlling variations in the process. The work in this paper will present a developed integration…
Modern data collecting methods and computation tools have made it possible to monitor high-dimensional processes. In this article, Phase II monitoring of high-dimensional processes is investigated when the available number of samples…
Monitoring the quality of statistical processes has been of great importance, mostly in industrial applications. Control charts are widely used for this purpose, but often lack the possibility to monitor survival outcomes. Recently,…