相关论文: HitPix3 -- a new HV-CMOS active pixel sensor for i…

Pixel sensors in 3D technology equip the outer ends of the staves of the Insertable B Layer (IBL), the innermost layer of the ATLAS Pixel Detector, which was installed before the start of LHC Run 2 in 2015. 3D pixel sensors are expected to…

Three-dimensional (3D) histopathology of unprocessed tissues has the potential to transform disease management by enabling volumetric characterization of tissue microarchitecture and in-vivo assessment. Back-illumination Interference…

Space-based gamma-ray telescopes such as the Fermi Large Area Telescope have used single sided silicon strip detectors to track secondary charged particles produced by primary gamma-rays with high resolution. At the lower energies targeted…

Monolithic active pixel sensors with depleted substrates present a promising option for pixel detectors in high-radiation environments. High-resistivity silicon substrates and high bias voltage capabilities in commercial CMOS technologies…

Space-based gamma-ray telescopes such as the Fermi Large Area Telescope have used single sided silicon strip detectors to measure the position of charged particles produced by incident gamma rays with high resolution. At energies in the…

During the LHC Long Shutdown 3 (2026-29) ALICE will replace its three innermost tracking layers by a new detector, the "ITS3". It will be based on newly developed, wafer-scale monolithic active pixel sensors, which are bent into truly…

The Medipix3, a hybrid pixel detector with a silicon sensor, has been evaluated as a beam instrumentation device with proton and carbon ion measurements in the non-clinical research room (IR1) of MedAustron Ion Therapy Center. Protons…

To detect tracks of charged particles close to the interaction point in high energy physics experiments of the next generation colliders, hybrid pixel detectors, in which sensor and read-out IC are separate entities, constitute the present…

Strip and pixels sensors, fabricated on high resistivity silicon substrate, normally of p-type, are used in detectors for High Energy Physics (HEP) typically in a hybrid detector assembly. Furthermore, and owing to their inherent advantages…

CMOS Monolithic Active Pixel Sensors (MAPS) are proposed as a technology for various vertex detectors in nuclear and particle physics. We discuss the mechanisms of ionizing radiation damage on MAPS hosting the the dead time free, so-called…

Iris recognition is widely acknowledged for its exceptional accuracy in biometric authentication, traditionally relying on near-infrared (NIR) imaging. Recently, visible spectrum (VIS) imaging via accessible smartphone cameras has been…

The High Luminosity upgrade of the CERN Large Hadron Collider will be able to reach a peak instantaneous luminosity of 5E34/cm2 s. The innermost detectors of the CMS and ATLAS experiments will have to cope with unprecedented requirements on…

MuPix11 is a High-Voltage Monolithic Active Pixel Sensor (HV-MAPS) developed for the tracking system of the Mu3e experiment. The in-pixel photon response of a MuPix11 sensor thinned to 70 {\mu}m was measured using an 8 keV X-ray beam with a…

Depleted Monolithic Active Pixel Sensor (DMAPS) sensors developed in the Tower Semiconductor 180 nm CMOS imaging process have been designed in the context of the ATLAS ITk upgrade Phase-II at the HL-LHC and for future collider experiments.…

Bent monolithic active pixel sensors are the basis for the planned fully cylindrical ultra low material budget tracking detector ITS3 of the ALICE experiment. This paper presents results from testbeam campaigns using high-energy particles…

The Inner Tracking System (ITS) of the ALICE experiment at CERN will undergo an upgrade during the LHC long shutdown 3, in which the three innermost tracking layers will be replaced. This upgrade, named the Inner Tracking System 3 (ITS3),…

Thin planar pixel modules are promising candidates to instrument the inner layers of the new ATLAS pixel detector for HL-LHC, thanks to the reduced contribution to the material budget and their high charge collection efficiency after…

We present an innovative charge detector with high resolution and wide dynamic range designed to fulfill the requirements of a monitoring system for a high energy ion beam. The detector prototype, constructed using Si photodiodes and a…

The ALICE ITS3 is a novel vertex detector replacing the innermost layers of ITS2 during LS3. Composed of three truly cylindrical layers of wafer-sized 65 nm stitched Monolithic Active Pixel Sensors, ITS3 provides high-resolution tracking of…

In order to achieve the challenging requirements on the CLIC vertex detector, a range of technology options have been considered in recent years. One prominent idea is the use of active sensors implemented in a commercial high-voltage CMOS…