相关论文: Design of an Efficient Three-Level Buck-Boost Conv…

Scalability and modularity are key features for future power converters, such that these systems can be easily employed in many applications with different electrical specifications. In this thesis, the potential of a new bidirectional…

This paper presents design and control of dual-switch non-inverting buck-boost converter (CBB). This converter is designed to simplify the compatibility of electronic ballast with simple and low cost LED drivers. The converter provides…

This paper presents comparative performance between Analog and digital controller on DC/DC buck-boost converter four switch. The design of power electronic converter circuit with the use of closed loop scheme needs modeling and then…

This paper proposes a new DC-AC converter with a less number of semiconductor switches and therefore gate drive and control circuit components. A salient feature of this inverter is its pure sinusoidal line-to-line voltages with no need for…

Appropriate control contributes essentially in the design of efficient DC-DC converters. With this intention, a study deals with the synthesis of a controller for DC-DC Three-level Boost converter (TLBC), has been addressed. The studied…

Global demand for clean and eco-friendly energy sources has inspired decades of far-reaching research in power generation from renewable energy sources. Solar cells, wind, and tidal sources are limited in output power generation compared to…

On-silicon inductors using a bulk 0.18 {\mu}m CMOS process have been designed. By shunting different metal layers in parallel, inductor values and quality factors were simulated. Selected inductors were then employed in two open-loop buck…

A critical challenge in power conversion in electric vehicles is the efficient use of DC-DC buck converters that need to provide 12-V supply for load systems from 400/800-V batteries. This paper presents a literature review on the…

This paper describes a SIMO DC-DC converter capable of generating all the required voltages (buck and boost) utilizing n-type transistors for the output switches. The design incorporates only one shared bootstrap capacitor and a single pad…

In this paper, we focused on the design of an adaptive backstepping controller (adaptive-BSC) for direct power control (DPC) of a three-phase PWM rectifier. In the proposed system, it is desired to control both the output DC voltage of the…

This paper proposes a programmable multi-input buck-boost structure method, which can enhance the operation tolerance for the PV array under extremely harsh climatic conditions. The proposed structure based on a traditional two switches…

This paper reviews commonly used three-phase isolated AC-DC converters and introduces a novel Y-configuration Active Bridge (YAB) converter for single-stage isolated AC-DC power conversion. The proposed YAB addresses the limitations of…

This paper presents the design and analysis of a high efficiency, PWM (Pulse-Width-Modulation) Buck converters for mobile phone applications. The steady-state and average-value models for the proposed converter are developed and simulated.…

Power flow feasibility assessment is computationally challenging for unbalanced three-phase distribution networks. This paper develops a vectorized semidefinite program (SDP) based on the bus injection model (BIM) and reformulates its dual…

A common configuration for a stand-alone PV power system may consist of three converters: a buck converter for the PV panelto charge the battery, a boost converter for the battery to discharge to the load and one for the load voltage…

The paper considers a DC-DC buck power converter employing pulse width modulation and voltage feedback control. Global asymptotical stability of a periodical operating mode is examined. It is shown that the stability analysis can be reduced…

A high step up dc dc converter based on an isolated dc dc converter with voltage multiplier cells for photovoltaic systems is essentially introduced in this paper. The proposed converter can provide a high step up voltage gain. The switch…

This paper addresses the problem of regulating the output voltage of a DC-DC buck-boost converter feeding a constant power load,which is a problem of current practical interest. Designing a stabilising controller is theoretically…

This paper proposes and evaluates a novel architecture for a low-power Time-to-Digital Converter with high resolution, optimized for both integration in multichannel chips and high rate operation (40 Mconversion/s/channel). This converter…

This study presents the modeling, control design, and performance analysis of a DC-DC buck converter using state-space averaging techniques. Buck converters are essential in modern power electronics for regulating DC voltages in renewable…